Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi all, I connect TP-Link extender AC1750 to WLC 3504 network but the client doesn't get internet connection. The extender's configuration is simple (connect to host SSID and broadcast ext SSID). It's network map is shown as internet connected. The c...
Good Afternoon all, During a recent install i had a bit of a nightmare installing a batch of MR44's that were new but had been in storage for a little while (approx 9-12 months). The AP's were in the Org's inventory so was just a case of moving them ...
Hello Professionals,I would like to create one account for my team member with limited access rights.On the controller, multiple SSIDs has been created and most of them are having L2 security authentication (mac filtering).I would like to let user ca...
Hey Guys,Have you experiment something like this in your network? is a common behavior? I have a WLC 9800 and DNA just for monitoring and TS. AP 9115 AXI. and good distribution of AP in the floor, we already did a sitesurvey. The channel selection i...
We upgraded the access points firmware on MR 36 from MR 29.4.1 → MR 30.7 and since then we have had multiple users complaining about poor wifi connections.Teams calls cutting out, warnings of poor internet connectionsWe didnt have this issue before w...
Hi,Might not be the optimal place to ask about a Microsoft-issue, but we have many enterprise laptops running the latest windows 10 with intel wifi-cards that support 802.11r. The SSID is running FT adaptive, and iOS-devices are successfully connecte...
Hi EveryoneI'm seeing the following message in my logs every 30 seconds:396901: Apr 2 2014 13:31:20.958 BST: *capwapPingSocketTask: 1 wcm: %CAPWAPPING-3-PKT_RECV_ERROR: capwapPingSocketTask: capwappingRecvPkt returned errorDoes anyone know what thi...
Hello I hope get some guidenance on how we can resolve this issue. We have certain 2nd floor rooms that are having issues with Wifi connection named Student. The students can connect to it on there chromebooks but connection is slow and lagging. Mean...
Hello.In policy enforcement by device type, IPHONE is set to BLOCK for SSID.However, your iPhone is not blocked.Do you have a case like ours??What is the solution??I've contacted Meraki support, but it doesn't help.Please help me
Hello team ,we have a setup of C1852 as WLC and joined CAPWAP AP 9130usually the default mode for 9130 is dual mode with means slot 0 for 2.4 and slot 1 for 5 GHZi found that it operates in Tri mode which means it has slot 0 for 2.4 and slot 1 and sl...
Trying to setup redundancy on 9800-Cl in Esxi environment. Have three NICs - Gi1 ( OOB ) , Gi2 ( trunk ) , Gi3 ( HA ) . After issuing following commands and reloading controllers one of the controller goes into recovery mode and HA is not formed. Co...
Hi All Can anyone tell me the benefits of increasing TX power on an access point? does it allow the signal to go further? or faster etc ?
Hi all and thanks in advance for any advice.I have had the same issue now with two 9120AX APs where following a hard reset, pressing the reset button for longer than 20 seconds, I'm unable to login to the device either by SSH or console. Neither the...
[*09/04/2024 18:35:52.0000][*09/04/2024 18:35:52.0001][*09/04/2024 18:35:52.0001] CAPWAP State: DTLS Setup[*09/04/2024 18:35:52.3783][*09/04/2024 18:35:52.3783] CAPWAP State: Join[*09/04/2024 18:35:52.3797] Sending Join request to 10.48.40.45 through...
I was wondering if there was a way to see the last known connection for an access point. When an access point is connected, The dashboard will show you where the access point is connected (Switch name, IP address and port number on the switch). After...
