Wireless

Does anyone know the power rating of a 1552e mesh AP before the antennas are attached? I have the dual band 2.4 / 5 GHz antennas. I know their Db rating, but I have not been able to find what the AP is. Anyone know?Sent from Cisco Technical Support i...

I have this situation where we need to explort WCS data to Prime infrastructure 1.2 (or 1.3)The problem is that the Prime 1.2 is already setup for the nework and WAN.Is it possible to migrate the WCS data on top of a existing database on a Prime serv...

Hi Team,We are getting problem only with HP ProBook 4440s laptop when try to connect on wireless through 1142 access point. As the same time if we try to connect from 1252 access point it connecting. Both AP is connected with same WLC. Also we are tr...

My questions is in relation to disaster recovery, for wireless.  We have our main data center, in the US, with two 5508 controllers.  We have a DR location, in Europe, with two 5508 controller.  We're upgrading our 5508's to the 7.4 code, so that we ...

Hi therewe ordered the Cisco Prime Infrastructure 1.2 licenses with a valid service contract just before PI 1.3 was released. Now that PI 1.3 was published, is it possible for us to install directly PI 1.3 and to license it with the PAK's for the 1.2...

Hi there guys,i have a WLC with, let´s say, 30-40 AIR-LAP1142N-E-K9. Since last november the following issue happened 3 times.One of the APs (it´s always the same unit) remains online but both WiFi interfaces appear down. I´m unable to put it back UP...

5508 WLAN controller with 50 AP License upgrade from 7.0.220 to 7.4 is it will effect to the license and configuration? Because the license came pre-installed.  How to upgrade step by step process please.

ThanksSent from Cisco Technical Support iPhone App

Hello, how can i replace my wlc2504 to a WLC5508 without disconnecting everybody, i have 3 SSID, on different VLAN...I want the WLC5508 to be the main WLC, so i can remove the 2504 from the network.On the WLC5508, it will be the same configuration of...

Hi Team,I am running big wireless network, with 20no of 5500 with 7.0.116.0 version. I have more than 20,000 AP's. If i add some config in primary controller or do some changes or reboot all the AP's are moving to backup controller. this doesn’t have...

Hi I am having wireless (2504)  controller with 10(AIR-AP114) AP connected to it. And they are connected in my  network to internet.I want to give different SSID with different level of security.Example:SSID 1 : Guest  (access level limited)SSID 2 : ...