Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Resolved! Wireless Roaming

Hello,Having gone through the Enterprise Mobility 4.1 Design Guide, I understand there are several types of roaming options:Layer 2 roaming (within 1 or multiple WLCs)Layer 3 roaming (multiple WLCs)I wanted to find out if Layer 3 roaming (APs in diff...

titusgateri by Community Member
  • 1192 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have problem with my WLC2504. My WLC is  connected through two ports (1 and 2 of four) to my distro switch, where  I have dot1q trunks configured. WLC is configured with Management interface  (IP address 192.168.255.9/24), over which my  LAPs ar...

Dear All,Our offcie use WLC2100 Series controller with AIR-LAP1031 and successfully join and running. Now i am trying to replace one ap with AIR-LAP1041N and join with WLC, but i can't and below  the error message generate:"*Mar 25 02:37:28.000: %CAP...

Hi,Can anybody comment on the mounting for the above antenna types.  Please see figures below.                   The figures above, are the antenna mounting correct?  For figure 1, can the two antennas be separated by 4" or more?  For figure 2, the t...

mcaoile by Level 4
  • 1011 Views
  • 5 replies
  • 0 Helpful votes

I am still new to wireless. I have been studing for my CCNA Wireless for about 6 months now so I still have a lot of questions.Right now I have to deploy some new APs. We are using 3502e APs. I have a qustion on how to mount antennas for these access...

Cisco1619 by Level 3
  • 1379 Views
  • 7 replies
  • 0 Helpful votes

Looking to upgrade WCS from ver 7.0.172.0 to ver 7.0.240.0.Is it as simple as installing the exe ? Will it regain all of my current settings in WCS ?Any advice would be appreciated.CheersDave

dclee by Level 5
  • 672 Views
  • 2 replies
  • 0 Helpful votes

Hello, I am still somewhat new to the wireless side and I saw something today while trying to troubleshoot a wireless issue we were having that I have not heard or read about from my CCNA Wireless studies. I noticed that the antenna types our WCS is ...

Cisco1619 by Level 3
  • 1399 Views
  • 2 replies
  • 0 Helpful votes

Hello,i'd like to integrate TACACS+ Integration into NCS.I configured my ACS 5.1 correctly, but I get an "Access is denied to NCS" at the web login page. In the ACS i see a successful authentication.Any ideas?regardsAlexHere is my Shell Profile Confi...

Hello Cisco Community,I read in data sheets and the latest antenna Guide that the antenna AIR-ANT2566P4W-R is compatible with the Cisco1602E series access points. Because this antenna is a 4 Port antenna and the access point has only three RP-TNC con...

Review Cisco Networking for a $25 gift card