Wireless

Dear all,I read a lot about VPN via an iPhone (Cisco Anyconnect), but is there anyone who can tell me if or how I can make a VPN connection via my iPhone to my WRVS4400N v2?I have to fill in some fields in my VPN settings on my iPhone wich I can't fi...

Hi experts,We are in middle of deploying WiSM2s on our network, from a design point of view i am confused on where to position the WiSM2s. We have 2 DCs and from best practice architecture view WLCs should not be placed on the Data Centre segment, bu...

We have just discovered a problem with 802.1x authentication and Atheros cards.We have seen this on both MAC OS X 10.6.0 systems and an XP SystemThis appears to be a DHCP problem in that clients don't get an IP address unless they reboot- which usua...

Good morning, I am currently installating 3502 Lwapps across my enterprise. I am currently utilizing 3502i(internal antennas) in the customer facing areas and 3502e(external antennas) in the warehouse areas.  The 5 Ghz antennas are 3.5 dBi and the 2....

I am working with 4 x 1522 mesh ap's. 2 roots and 2 mesh. Both roots are connected via fiber (single strand SFP). The mesh was up and running then all of a sudden root 1 dropped off and joined back as a mesh. All the Ethernet interfaces from root 1 j...

ACS 5.1 EAP-PEAP Machine AuthenticationAll, I have configured ACS 5.1 to check AD domain computer accounts then permit access, the next rule authenticates AD domain users and checks machine accounts with WAS MACHINE AUTHENTICATED "TRUE" permit.My dil...

Is it possible to configure two 1300 series bridges at one location, each handling a bridge link to another location to BOTH backup and load balance for each other should one of them fail?

HI In my site i am running WCS with 5.0 version on a Linux server .From past 5 days i am seing the WCS application is not responding properly .Once i restarts the server it is working for some time and again its getting unresponsive .Did anyone faced...

Does anyone know how an ASA and a guest anchor 5508 will interact if I setup an Active/Active failover pair with physical interface redundancy?  I see from documentation that I can create a logical group in the ASA to bond physical interfaces togethe...

Hello together,I try to find a general solution to the following problem:Cisco WLAN environment, >50 intelligent APs, >300 WLAN User, multiple SSIDs. Behind every SSID is a different VLAN. DHCP enabled on the clients. The users standard of knowledge ...

Due to lack of address space, I have to go to NAT for our wireless guest users.Are there any limitation with WLC/NGS when comes to NAT?I have four 5500 WLCs, should I put them in 1 mobility group, at 2 different locations?ANy doco on WLC NAT would be...

Hello all,We have just configured MAC Authentication for our wireless WLAN via the Cisco ACS Radius Server.The server is configured with a list of MAC addresses to allow on the wifi network and the controllers send authenticationrequests to the radiu...