Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
HiI have 2 sperate DHCP servers installed at my office.One is hosted in a cluster enviornment and the other is on a single seperate windows server.Both my LAN and wireless clients are getting DHCP IP from the single serverBut only my LAN clients are ...
I have a problem, the wireless client PCs do not get ip address via DHCP how can you fix this?
Hi,I've just installed a 2106 Controller at a remote site. The Controller is seen by the WCS at the main site so, connectivity is good and I'm able to login from the main site. I've configured the DHCP server which is at the Main site on the AP manag...
Hi Folks,I am facing a strange issue with a Wireless Bridge Setup which i configured 3 days ago. Everything was working normal for a couple of days until yesterday when the setup stopped working.On check what happened, this is what i was able to find...
I am a installer and I reversed the wiring on the RJ45 connecter that plugs into the ethernet port on a Aironet wireless access point! It was already connected to the switch. So Pin 1 on the WAP RJ45 connector is Pin 8 at the switch and so on.The sta...
Hi,I have hear about the cisco prime network control system (http://www.cisco.com/en/US/prod/collateral/wireless/ps5755/ps11682/ps11686/ps11688/data_sheet_c78-650051.html) but I can't find a way to download it, the link which is supposed to have the ...
Just wanted to check to see if we still have to manually set the offset on the controllers to fake DST? I don't see anything in the new release notes that indicate support for DST automatically. Also, this should propagate to the APs as well, right...
I am using a SPIRENT SR5500 Channel Emulator to simulate a channel for 2 Aironet 1310s. I have the APs set to 1mW output which should be ~0dBm yet the triggered setting for the power meter within the SPIRENT SR5500 is showing ~-20dBm at the output o...
Resolved! Web Auth login page
Does the new 5500 WLC support multiple Web Auth login pages? I want to consolidate my WLCs to a central location and possibly just one controller. I have several different guest wireless networks for different departments and each has a customized We...
Hi,I've just installed a 2106 Controller at a remote site. The Controller is seen by the WCS at the main site so, connectivity is good and I'm able to login from the main site. I've configured the DHCP server which is at the Main site on the AP manag...
Hi Guys,I was wondering if anyone can tell me if the AP 1131AG supports IPV6?Thank you
Does AP 1131AG support IPV6.
Last night, I upgraded my WISM software to v. 7.0.116.0. The upgrade went smoothly. Most of my WAPs are H-REAP and they are working fine. I have a few local mode WAPs that are stuck in a downloading state. They will try to download, reboot, then try ...
Hi,We have started to implement lightweight APs with WLCs on a couple of our locations. Our initial design was to put in two 5508s on each locations that have around 30 APs installed, to save on $$ we were thinking about re-deploying the second WLC 5...
Good morning, I am trying to measure the actual output power from a pair of Aironet 1310G's. They are both set to 1mW and 1MBPS, the antenna ports are connected by cables measured to 1.5 dB of loss to a channel emulator with a built in power meter....
