Wireless

I have a number of WLC using a Cisco ACS ver 4.2 on Windows and EAP TLS to authenticate Corporate WLAN clients from a back end domain.Is there any way that is the WLC gets an authentication fail from the primary ACS it will attempt the secondary ACS?...

New 5508 controller, can ping it and ssh but no https. Is there an initial cli configuration I'm missing here ?

In the following output of the "Show Dot11 association <MAC>" output, does the "Signal Strength" entry show the dBm as the BSSID sees the client, or what the client reports their recieved signal as?  Also, is there a page that describes these entries...

Hello,I have 2 WLC in my network and all APs are configured in H-REAP mode local switching, central authentication. The initial association occurs in the right way and the network works just fine, but suddenly without being espected every AP from the...

I have a WLC526 running sw version 4.2.61.8 that I finally got around to installing in my shop for testing after sitting on the shelf for several years.  Since it's now out of warranty and I'm no longer certified getting the latest sw version isn't p...

Where can I find the info about what APs a Controller supports? for instance 2100?thanks,Han

Hello Dears,there is a campus, and i need to make wireless survey, they want to cover with wireless connection their yard, streets near the buildings, some points too, so i have a question, they need indoor type of wireless access point ? or outdoor?...

Does anyone know of any recommendations regarding sizing of: - AP subnets - Client subnetswhen designing Cisco wireless networks?I've checked out the design guides and various FAQ's etc., but haven't come across anything obvious.In the case of AP sub...

Having a problem wih intermec PM4i barcode printers with wireless network cards  disassociating from a 5508 controller in a production plant, The printers have ip address that have a static IP address that is from vlan 2 ( wlan that the printers conn...

Hello everybody.I've set up a WLC2504 with interface "mgmt" and "guest" (2 different VLAN IDs) both configured on port1.Now I'd like to be able to connect to PoE ports (port 3 and 4) 2 LAPs which should be able to get IP addresses from the DHCP as if...

I just got a new requirement for our wirless rollout and I need some help. Plan the best way to provide employee and guests wireless access w/ the guests separate from the production environment.We have a 5508 controller w/ 1142 APs. I have two GBICs...