Wireless

Is it possible under the 7 version of the software to use LDAP or Local Net Users for authentication instead of RADIUS for doing 802.1x authentication, and if it is, is there any documentation around that has some configuration information?  I've bee...

Hi,Is it possible to configure on the WLC jamming radio signals from other AP's?Kamil

Hello,I'm struggling with a bunch of Symbol (Motorola) WT4090 scanners that don't seem to roam properly.  WiSM shows them as CCX not supported.  Cisco shows this dvice as CCX compliant but Motorola says they chose not to become CCX compliant but rath...

Hi folks.We have a wired network that has a utility the broadcasts udp, and clients pick up the heartbeat and attach. It works fine on the wired, and we can see udp packets. However, we don't see any udp on the wifi.I have enabled broadcast forwardin...

Hii have a wlc 2106 , when a user want to connnect to the wireless , it will show the log as below . the user can not connect to the wireless network .After disable and re-enable the wifi nic or connect to another AP(not cisco ) and retry to connect ...

I have an Aironet 1200 with 3 SSID's attached to 3 vlan's. I need to create a way to get all vlan's over wireless, to a wireless bridge (WET200), where I can then setup the ports for specific vlan's. I cannot change the aironet over to a bridge. I ne...

Hi,we do have a pair of AIR-BR1310 connected together at about -55dBm. Everything looks fine but if we are transmitting data over this link we can see crc errors rising up quickly on the radio interface of one of the bridges. On the other side there ...

I am using Cisco Configuration Professional 2.2 to set up an 861-W router. When I add a wireless network and configure the wireless LAN to a wired VLAN that has a DHCP pool, do I need to do anything further to get the wireless LAN to hand out the DHC...

Has anyone installed WCS 7 on Redhat Enterprise 5.5 and gotten it to run successfully ?

Good morning support,Is possible to configure a WLC to auto backup its configuration every day?Thanks for your supportBest regardsFran

I'm having problem with ASA 5510 and WLC 526, in  this case the ASA provides DHCP, I created 3 vlan's (12 administrative,  13 visits, 10 AP's). WLC 526 has two network interface, eth0 in this vlan  10, and eth1 is in a TRUNK port on the switch in val...