Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

HI,I went through below linkhttp://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtmlI have the same setup except the dhcp.I have dhcp server which is givng IP to clients; I want to divide clients as bulding...

Resolved! MSE with WIPs

Hi,I want to know, how does the WIPs works in MSE. I have implemented the CAS but don't have idea about the working of MSE when using WIPs on WCS. Can you please suggest or show me a link which gives me the idea. Any help in this will be really appre...

Hi,I have a 1142N which does not join the WLC when connected via a 2960 switch. When I connect a different lap 1142N to the same port on the same switch using the same cables, it does join the lap to the WLC. And when I connect the first lap directly...

5avelsberg by Community Member
  • 3203 Views
  • 12 replies
  • 0 Helpful votes

hi,is there any technology where we can extend the layer 2 over a layer 3 link (other than nexus OTV)?Basically i want to extend the vlan over a routed link, is this possible ?thanks

Hello Dears,I have wireless module, and when i do sh ip int brief command in router(whis is module connected) i see two interfaces:1)Service-engine interface2)Integrates-services-engine interfaceWhat is the difference between themModule has only one ...

HiI got a few messages during a day that APs have been gone down:2. Message: 802.11b/g interface of AP MYAP is down: Controller 10.15.15.15A few minutes later the AP came back to the controller with the message:4. Message: Access Point 'MYAP' associa...

var-node by Frequent Visitor
  • 12002 Views
  • 13 replies
  • 0 Helpful votes

I just recieved in the mail an aironet 1042n ap. It was assigned an ip of 192.168.1.254 by my router. When I attempt to connect it prompts for a password and states the default username and password is admin and 1234. It will not except this, or Cics...

admin by Community Member
  • 15257 Views
  • 3 replies
  • 0 Helpful votes

Hi, I've got two Cisco Aironet 1140 Access Points in my office. They're both setup as AP at opposite ends of the office with the same SSID, so employees can walk throughout the office without losing connectivity. We recently re-started one of the AP'...

dchanlive365 by Community Member
  • 2549 Views
  • 6 replies
  • 0 Helpful votes

Does cisco 3600 support office extend feature? If yes, is there a controller requirement?I know cisco AP 600 supports office extendThanksSent from Cisco Technical Support iPhone App

Review Cisco Networking for a $25 gift card