Wireless

Hello!Can someone do a auto-backup of the firewall SA-520?Especially with "wget" or "curl".Thanks a lot!

Model E2000Firmware: 1.0.04Using 2.4 channels All devices that are connected wireless through this access point have the difficulty of dropping internet momentarily. When ping from wireless devices to comcast.com with -t I get:This happens about once...

hi,I have cisco wlc 4404 and access point 1242AG A-K9when I try to connect ap to WLC, it is showing me down statuswhen i take hyperterm of AP, one of the radio interface status showing me as administratively down.

Hi allI am configuring an anchor controller for my guest wireless internet access.Firstly, does the config need to have all the same config, SSID's etc on it, the same as the other controllers, or is it a minimal config?also, how does the web traffic...

Can someone point me to a link that will give configuration examples of a wireles anchor config with one controller in a DMZ. I have tried this on my own and have some problems in my test enviorment. I believe my issues were with the firewall but not...

Hi,Does any body know what is the maximum of simultaneous connections that the AIR-LAP1131AG-E-K9 access point supports?Any help is much appreciated!

Hello,our custom, ask me if is it possible to install a WCS on Linux/Debian ?Thank you for your help !!!Laurent

Hello,I am trying to bring the mobility group between 5508 wlc (dmz) and internal 5508 wlc but it says control and data path down. (Ihave allowed port 97 and ports 16666-16667 both ways)1. should the ntp be sinked inline iwth other controllers ?2. sh...

hi,I am setting up officeexten. jsut have a few queries regarding the setup.I have placed the officeextend wlc in the dmz with an mgmt ip of 192.168.10.2. in the process of anchoring this to the internal wlc. Also the ip on the firewall for this inte...

Hello,I must design an architecture for a mesh deployment with 1552 access points. Quote has been done with 1522, but it seems that these access points are in end of life.On previous deployment I've made with 1522, it was possible to have a remote 5G...

hi,I have setup a wlc (mgmt add 172.22.15.254) in the dmz connected to the fierwall with a security level of 30. I can access the wlc mgmt addres from firewall (have a address on the firewall for the same range ex 172.22.15.253). i cant seem to acces...

Hello,I Would like connect few Aps Cisco 1242 on WCS with snmpv3 in the same security WLCs. I have a probleme to add manually AP1242 on this WCSFor AP Cisco 1242 snmp v3 don't existe by browser web then ,I added follow line in CLI command :Cisco1242(...

Hi everyone,i need to let that only one user can get access to wireless network, it means user1 who has your own username and password can authenticate to wireless and if any other people know his or her auth data can not connect because the "right" ...