Wireless

If I use machine and user certificates does that mean the machine get's an IP address, authenticates, the user then logs on which causes another DHCP renew and user authentication?  Is it better to use machine and user or just machine?

Is there a way to set up web passthrough as HTTP, instead of HTTPS? We wish to set up a hotspot where the only data shown to our users is the Terms of Service.  Our users wouldn't provide any info, only hit the "Accept" button.  None of this informat...

HIJust updated wisms with ver 7.  Went to check with WLC Config Analyzer, but when I run sh running-config each controller it now crashes my telnet session which doesn't give the full cfg.  It crashes at the same place each time when ran on the contr...

Hi Problem: When trying to connect to the network using AP it takes about 10 - 15 secs to get reply. But if connected through ethernet its as normal.Scenario: 2 WLC ----> Cisco Switches  (3550/3750) ----- > Cisco AP ----> Scanners/Guest Vlans. Authen...

I got PEAP to work using the windows zero config but I cannot get PEAP to work when usin CSSC on the same laptop.When using CSSC I get asked for the password and authentication fails.  ACS is reporting PEAP authentication failed due to unknown CA cer...

I have a 1131 AP and it wont respond when I tell it to via the controller to go back to its factory default settings. Does anyone here know if there is another way to whipe the AP?

Hi,I have 1131 access point and by mistake , I have deleted the flash and there is not any file other than ( env_vars )  file . now i am trying to load autonomous IOS but i am not able to do.I have tried setting the IP address with below commandsap: ...

Hi,I have recently uploaded the autonomous ios in 1131 ap and i am able to configure the ap. but if i want to save the configuration in startup config , i am not able to save it.Once i reboot the AP , i am getting default configuration .is it related...

Dear,The vlans created for the mapping of SSID in embedded AP on cisco 1941 can be connected/communicated to the VLAN created on Layer2/3 switch.Lets say i have created 3 vlans (say 200,201,202) for 3 ssid and the vlan created on switch (say 200,201,...

Hi,I was wondering if it is possible to use Dot1X Port Control on a Wireless Network.What we would like is when a user trys to authenticate with PEAP-MSCHAPV2, if they pass they are allowed access to the WLAN. If they fail authentication they are mov...

Had a recent install with Veisign certs thats was fun.Therefore looking at some questions before I deploy the openssl cert for guest access.Reading the docs it says the following"Ensure that the host name that is used to create the certificate (Commo...

Hi AllI got a issue with AP 1231g it wont take any Light weight commands after I conected to the controller any help is good....I reset the item too default same issue....  in about 10 AP.thanks guyssincerelyJC

Hello,I tried to configure controllers (Wism) to allow multicast traffic (Video) from wired lan source toward wireless PCs. But it doesn't work.Although it works properly on the wired LAN from the same source, when I enable broadcast and multicast (...