Wireless

hello friends,i have a WLAN setup for two building and both have layer 3 OSPF connectivity to each other let's call Bldg1 & Bldg2i  have wism installed in Bldg1 in cat6509 series distribution switch  while i Bldg2 is connected on Bldg1's Core switch ...

Dear friends,what is interference actully in wireless system? what is best pracitce to decrease the interference in wireless system?why the interference happen and how i can stop or decrease it?many thanks in advance

A rogue containment policy is being initiated against my organization's APs and I do not have the tools/knowledge necessary to track down its point of origin. What tools or steps are required to identify who is containing an AP?Thanks

Does anyone have this problem when applying vlans to WAPS from the WCS?AP Parameters** HREAP: Profile NAME-VLAN Id mappings cannot be applied since VLAN Support status is disabled on the template.I have everything seperated out for my templates.  Ena...

We setup the mgmt interface of the WLC2504 on the subnet (10.1.1.0/24) with Cisco ASA 5505 to the internet. Can we create 2 WLANs on 2 different IP subnets (10.1.10.0/24) for internal users and (192.168.100.0/24) for guest without layer 3 routing?

So first post, I usually figure most of this stuff out. I have this all working with latest firmware etc, but I have more of a MS IAS issue than anything. The Peap cert used is one generated for my IAS controller, but I have two things... I'd like it...

Hi I have a cisco 881w with the following config on the wireless and wired, I can get a dhcp address on the wire on vlan 1 and get out but the vlan 2 should be handing out 172.16.31.x addresses to the wireless and is not any help would be greatROUTER...

Hi all,Anyone delved into the use of RADIUS attributes to apply QoS values (DSCP/802.1p) to wireless users via a WLC?With the emergence of ISE and the concept of a shared SSID for several user types I may want to apply QoS profiles by user rather tha...

HelloI have problems to connect a MAC-Server from the wireless-network (WLC-4402-50-K9, Version 5.1.163). The wired clients doesn't have problems to connect to the MAC-Server. The connection works over broadcasts. The wireless-network don't forward t...

Hi,Can i configure my cisco wireless controller 2106, 1 connection to CoreSW 1 and another connection from 2106 to CoreSwitch 2?Thanks

i have 10 linux based PC & i wan to connect these wirelessly throung Robin open mesh.shounl any one please tellme the procedure how to implement the it.Anil

Hi forumers'i experienced this problemlog copy from WLC : AP  'XXXXX', MAC : e8.ba.70.93:95:99  disassociated previously due to AP reeset. Last reset reason: oeprator changed 11g modesometime it will auto recover and joined, else need to manually unp...