Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi allWhen I order the AP 1130 Series Eco Pack (AIR-LAP1131-EK9-10), do you know what I get?I assume this are included:- 10 1131 Access Points - Mounting KitI know that the power supply are not delivered with the 1140 Series Eco Pack. Is it the same ...

azeindler by Level 2
  • 2324 Views
  • 7 replies
  • 0 Helpful votes

Hello All -I am looking to get some more information on the iPad in the enterprise. We are currently using Cisco wireless running a corporate SSID using WPA+WPA2 with AES and 802.1X. Is anyone running iPad's in the 802.1X enterprise? We use a Device ...

Hi,In the WLC 2112, I can connect Access Points in the available port.For example:WLC Port 1 --> Connected to Switch (802.1Q)WLC Port 5 --> AP vlan 50 (access mode)WLC Port 6 --> AP vlan 50 (access mode)WLC Port 7 --> AP vlan 50 (access mode)Thanks

Hello,Please, I need an official document from Cisco saying the APs models supported by the WLC 5508. Specially, I need to know if the AIR-AP1242AG-T-K9, converted from standalone, will be supported by the 5508.Regards,Marco Bartulihe

Hello,there are a lot of entries in the logs like the ones I show you:- AP's Interface:1(802.11a) Operation State Down: Base Radio MAC:58:bc:27:be:63:40 Cause=Radio interface reset. Status:NA- %RRM-3-RRM_LOGMSG: rrmChanUtils.c:290 RRM LOG: Airewave D...

I work for a company that installs Cisco equipment and was told that the maximum distance for optimal performance is to have the antennas no more than 5.5 inches and up to 20 inches apart. Is this statement true or false? I normally mount the 1242 AP...

albertt123 by Community Member
  • 17766 Views
  • 8 replies
  • 0 Helpful votes

I have a problem with an AP1131-AG access point.When I update the CLI it does not update on the GUI and vice versa. The access point is connected to a 3560 switch and there is no WLAN controller involved. Has anyone else come across this problem?

Hi,I have done some searching on the support forum about this topic. Seems that all solutions are null and void for us because we are not using SNMP v3 or H.We are using SNMP v2, We have upgraded our WCS to latest version as well as the controllers. ...

We have several ipad users, and they want to use Documents to Go to sync files with their desktop.I tested it over a small wlan with autonomous cisco AP's, and it worked.I then tried it on our LWAPP corporate WLAN, and the devices do not see each oth...

gordons by Level 2
  • 1416 Views
  • 1 replies
  • 0 Helpful votes
Top Solution Authors
Review Cisco Networking for a $25 gift card