Will the ap's be affected if you are upgrading a controller? I am would like to upgrade my anchor controller as the guest network is not functioning at the moment. Will this upgrade somehow affect ap's?
Hello!I am looking for a config to use the Vodacom SA 3G service with the 3G HWIC. They say they need no authentication but login does not work...Any ideas?Ralf
We have a solution using WPA2-AES with an odyssey client that will not load roaming profiles. I have done some research however there does not seem to be a definitive answer, do we need to implement machine authentication to pre authenticate the mach...
Does Cisco have a 5.8 Ghz wireless bridge available that does not require 2 separate strands of Coax between the power injector and the Bridge? I have been looking at the 1400 Bridges but using coax would mean I would have to run about 200 feet of c...
Dear experts,We have a setup of several 4402/4404 wlc's on site and one 4402 wlc anchor controller.Also a guest server version 2.0.0 is implemented.Corporate wireless works fine, my problem relies in guest access.All wlc's on site are linked fine to ...
Hi,We are taking over a new warehouse in the next few months. The business has a requirement for total Wireless Coverage on the Warehouse shop floor for use by stock pickers (with mobile devices). The key challenge I see here is the fact that the rac...
I have several dual radio 1252s and wish to create an indoor mesh to extend the 2.4ghz network to an area that cannot be data cabled.We are using wisms with 5.1 or 5.2 in the test environment.I can see examples of how to configure this with the 1240s...
Hi There,We are planning to use two Aironet's 1252 over an 2.7 km point to point link.One of the options we have it to install three HyperLink Parabolig Grid 5.8 MHz 27 dBi antennas in parallel for every 1252.I have some concerns because those antenn...
I pickup upa use 7920 off ebay to add to my call manager test lab. I am having issues trying to do to a factory reset. I have tried to access the admin mode but it locks up the phone. I know you can buy the configuration utility cd but i would rather...
How do I set up local dhcp scopes with two controllers. I guess I can not create the same scopes on both controllers ? What is best practice ?RegardsJF
When configuring my 4402 controllers I have to create the same interface on both controllers. But what about the interface ip-adress? Can the interface ip-adress be the same on both controllers ?JF
Hello;We have base licence for 100 AP on WCS. In our network we have 75 Cisco Aironet 1242AG series AP.But WCS give a error like "Percent of AP Licenses Used: Violation".When we look at the AP count, we see that there is a two record for each AP. On...
