Wireless

Hi,I am trying to build a solution for an SMB with mutliple access points for an indoor and outdoor solution (with Antennas), and looking for a cost effective controller. Looking at the 2106 I was wondering why only two PoE ports? Wouldn't it make se...

We have Cisco wifi setup at our office. Till now we had cisco Aironet access point -1000 series and the cisco Express- 500 series of switches. These switches inturn connects to wifi controller ( 4400 Series)  we do have wifi control system centrally ...

Folks,I've got an 877 Wireless router at home for testing and I'm struggling to get it performing.  I've plugged it into my current cheap adsl router to get the wireless up and working, but as I stroll into the next room, the cheap adsl router is sti...

Hi Guys,There is a pending issues with WCS when our AUDIT scan the WCS server running in WINDOWS 2003 the HTTPS services is running with a weak ciphers and i open a case to CISCO and provide me a bug ID CSCsx53619, WCS currently using a weak ciphers ...

This is part of the output from a show ip accounting:172.21.129.3     172.18.129.114                 419              334799172.21.129.3 is the IP of the AP-manager interface on my Wireless LAN Controller.172.18.129.114 is a computer on my wired netw...

I'm seeing the same problem as this: https://supportforums.cisco.com/message/3078877 but with a WRV210 router running 2.0.0.11 firmware, which is the latest. When a wireless client attempts connection, the router does not try to contact the Radius se...

I have a school that has recently update/upgraded their wireless infrastructure.  They had a number of dead zones, and areas with poor coverage.  We performed a site survey and identified a number of locations that required some additional coverage. ...

Hi ,I am new to wireless , i am facing client disconnection in my site .We use a Wism module on 6500 series switch .Some times when user tries to connect his laptop he will not get authenticated but after a restart it may work for some hours then aga...

Hello,Multicast Direct is a great feature for reliable video and broadcast voice messages in wireless.Is it possible to configure the Cisco wireless controller running the latest 7.x to do "Broadcast Direct"? I'd like to have the same reliability you...

We bought a Juniper switch that supports 802.3at in hopes of powering Cisco 1252 ap's.Cisco 1252 ap and EX200 are not negotiating to the higher power.  Juniper thinks that the 1252 is running pre standard poe and will not work correctly with the juni...

I have a working 1200 Access Point, that uses 802.1x PEAP authentication back to an ACS.  I want to enable 802.1x on the switch interface the AP connects to, Interface f0/2dot1x port-control autodot1x multiple-hostsWhen enabled the dot1x stays unauth...

Hi there,in our company we are currently in the process of setting up a new project which aims to have users access to certain services based on the hardware client and corresponding operating system they use. Those services will be provided over Cit...