Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
About two years ago you clarify my doubts about diversity, but today after seeing a hyperlink patch antenna data sheet, a doubt came to my mind, what if both antennas are identical and cover the same cell but with a little difference, the polarizatio...
I have an autonomys wireless network.1242 AP's and Cisco 3560 PoE switchs, WLSE.I have a new application for deaf interpriting in a hospital environment.No special configs just differnet ssids using WPA, Leap , WEP . This is one device that is on its...
Just installed a 4402 controller, 15 1242 ap's, configured WLAN and Guest WLAN, guests are prompted with the webauth login page while the account is active and they are working. Is there a timeout for inactivity?
does cisco has a radio planning tool for outdoor wifi networks??
Hi,I have tried to configure some AP's as mesh AP's using WLC4402-12 running 4.1.192.35M (Mesh)software version, working along with Cisco document crn4119235M.unfortunately i can't find the mesh tab under wireless->AP config...is there any country re...
I have added all switches in the network into WCS with snmp version 2c read only.When I try to trace one of rogue AP that I have connected into one of switch, the WCS return with an error message shown as below:"2009/04/14 20:02:34 Switch port trace ...
I found this in a cisco 1300 datasheet.---------------------------------------------------------------------------|AIR-ANT2414S-R* Cisco Aironet 2.4-GHz, 14-dBi sector antenna. |-------------------------------------------------------------...
This may be a simple fix and any suggestions would be appreciated.We have a hospital network, using Cisco 1200 series AP. We have plenty of AP coverage, signal strength stays excellent. The issue is we are beginning to run our main database system wi...
Is there a way to make a 7290 register with phones the are on a SIP ports.
can the 7290 be setup for SIP session? Is there firmware to upgrade 7290 to accept SIP port assignment to register?
Any help you can offer will be greatly appreciated!Per
Hi,I am using 5.2 WCS as the migration tool. The Autonomous APs have their IP addresses statically configured. I am using DNS to resolve the controller name.The AP resolves the controller AP then does nothing with it. It just starts broadcasting for...
I have an aironet 1252 access point and I have it set up with 3 ssid's which in turn are 3 separate vlans. My question is, can the 1250 supply dhcp to each ssid or only to the native vlan. This access point is going to be connected to a 4507 routin...
Currently we have 2 WISMs that handle approximately 100 AP's. We are looking to replace our 1242 AP's with the new N 1142's. I was wondering how many clients these 1142's can support compared to the 1242's? Most of our company laptops do not have N c...
Good morning! I hope that there is a Cisco wireless specialist able to help me. First question: I know that the 802.11a frequencies supported by 1240AG Access Points are: 2,412 to 2,472 GHz (13 channels) 5,15 to 5,35 GHz (8 channels) 5,470 to 5,725 M...
