Wireless

Hi,I am considering upgrading our WiFi APs (old Aironet 1100 Series) from our headquarter offices (25 users on large areas).I have contacted a Cisco sales rep and have been recommended the AP 3500 series with clean air and n technology.A few days lat...

Hi All,I am using Cisco 877W to provide wired and wireless conectivity to my users. We are having issues with the router refusing wireless connections after a certain number (most likely technical restraints), because the physical infrastructure is f...

Hi,In one document I see the following:Cisco 4404/WiSM controllers can support 125 simultaneous Web Auth Users logins, and scale up to 5000 web auth clients.Cisco 5500 controllers can support 150 simultaneous Web Auth Users logins. What about Cisco 2...

Hello,I connect first access point wap 2000 to router WRV200 by wired.second ap wap 2000 as repeater. Third AP as repeater.  its work but connection isn't stable.many packets are dropped and internet signal is bad.First ap work on channel 2 and wpa s...

I am having an issue with DHCP on our CAS 4.0.0 server.  I need to expire a DHCP lease or remove it because the device is going to use a reserved IP address.  The challenge I am having is that this device is an Apple IPad and apparently these devices...

we want to configure our WLC´s only through WCS. as i saw in the configuration it is only possible to do a manual "save config to flash". this means that we loose the configuration on our controllers when a controller is rebooted in an uncontrolled w...

Hi allI have a wcs installed with Every thing functioning properly.I am trying to see the path on which the floor plan get stored in the server.I would like to know that "is it possible to take the floorplan from the server" or "where is the image ge...

Hello All,i am new for this product so i need understanding what is the differnce between Cisco Access Registrar and Access Registrar Directoralso i need help to to configure below1) Bridge Authentication using EAP-FAST. (Bridge model 1410)2) Externa...

We have 2 WLC 5508s running v7.0.98.0 and 70+ 1230, 1240, & 1250 series LWAPs.  We are currently enabling LLDP because we will be installing some non-Cisco switches in the near future.  Does the WLC5508 and the access points it controlls support LLDP...

I have 3 bridges setup in this fasion.CHS_MLK ---- CHS_ROOT ----CHS_720CHS_MLK and 720 are both on buildings.  CHS_Root is the root bridge and it is mounted within line of sight of the other two bridges.  There is less than half a mile between the ML...

I'm working with a customer who wants to run PEAP using MS-CHAPv2. They are using the Windows XP supplicant.With prior versions of ACS (3.x, 4.x), I generated a self-signed cert on the ACS server itself and imported it onto the Windows machine.Is thi...

Hi,I recently upgraded our Cisco 4402 & 4404 controllers from 6.0.188.0 to 7.0.98.0 and everything went fine until 24hrs later all the access points disassociated and would not re-connect.The AP's sit with a single fast flashing green light. We are r...

The homepage can be customised for an individual user however I would like to customise the default homepage so all users receive that default homepage when they log in. Users are logging in via TACACS so I thought an a Custom Attribute may help but ...