Wireless

Is there a way on WLC or WCS to set up an SSID that would specifically cater to Mobile Devices (IPhone, Droid, IPad)?  Also if one were setup how could I go about policing this to be sure mobile devices only got to that SSID and no other ones?

I have a WAP200 AP configured with 2 SSID's.  The AP is configured to allow the use of repeaters and i have 2 other WAP200's acting as repeaters for each SSID.  The WAP200 repeater i have configured to repeat the signal for the 1st SSID works perfect...

Any there a way to stop advertising Cisco appliances on a WiFi network. For example when I logon to our in-band Guest Wifi using nmap I can see the Cisco Controller interfaces and the NAC server trusted and untrusted interfaces as well as the Web Ser...

Would anyone have a copy of the c1240-k9w7-123.8 JA.tar or commonly known as the default file. They don't have it available for download, and I need it to repair a c1242 access point which mistakenly got a 1200 tar file loaded on it!Karl

is it possible to map more than one vlan on one SSID.  or more than one AP group per Access point (I couldn't find such possiblility while looking at the WLAN controller GUI or cisco tutorial but I'm still curious if there is any way).

Hi,I was using 1100 AP in which it has some IOS problem so on my boss request, i tried to change/upgrade the flash: c1100 file.So, i deleted the flash file and at a sudden it completely went off red, green, red light order its glowing at status. It h...

If I use machine and user certificates does that mean the machine get's an IP address, authenticates, the user then logs on which causes another DHCP renew and user authentication?  Is it better to use machine and user or just machine?

Is there a way to set up web passthrough as HTTP, instead of HTTPS? We wish to set up a hotspot where the only data shown to our users is the Terms of Service.  Our users wouldn't provide any info, only hit the "Accept" button.  None of this informat...

HIJust updated wisms with ver 7.  Went to check with WLC Config Analyzer, but when I run sh running-config each controller it now crashes my telnet session which doesn't give the full cfg.  It crashes at the same place each time when ran on the contr...

Hi Problem: When trying to connect to the network using AP it takes about 10 - 15 secs to get reply. But if connected through ethernet its as normal.Scenario: 2 WLC ----> Cisco Switches  (3550/3750) ----- > Cisco AP ----> Scanners/Guest Vlans. Authen...

I got PEAP to work using the windows zero config but I cannot get PEAP to work when usin CSSC on the same laptop.When using CSSC I get asked for the password and authentication fails.  ACS is reporting PEAP authentication failed due to unknown CA cer...