Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hi, I'm from Brazil and I have a Access Point Cisco WAP4410N with PoE. So, I need to buy other, and I'd like the same model, but I only found the Access Point Cisco WAP4410N-BR on the stores in my city. I want to know if the WAP4410N and the WAP441...
I am looking for a solution to run my organizations Blackberry units over the newly laid 802.11n Wireless infrastructure using WPA2/AES authentication. The service provider is T-Mobile and it has the ability to hookup the BB units over WiFi allowing ...
I should know this and maybe I am over thinking the issue but I will explainI have 3 sites and 1 controller.We are not using H-REAP.What is the best way to seperate the sites on the controller so each site has its own RRM setup. I thinks using H-REAP...
I have an AP that has joined a WLC previously. I want to move it to a different LAN segment and assign it a static IP address. How can I configure this AP? I tried using the CLI,AP#lwapp ap hostname testAPERROR!!! Command is disabled.AP#clear lwapp p...
HiI am setting up a centralized WLAN solution wit two 5508 WLC an several decentrilized sites on different client subnets. I want to use the same SSID for all the sites but I am a little confused how I should set this up.Can someone explain me how to...
While troubleshooting some heavy VoWLAN troubles I need to get a better understanding of the trafic stream metrix data collection.I clearly have a problem with uplink packet loss. But where can thees packets bee lost.Is it only between the phone and ...
Hi,I have two lan segments. I have few queries ragrading the wireless connectivity between these two lan segments.1) Can I use AP 1252 as a bridge to connect both these lan segments ?2) If yes, which radio will it use 802.11g/802.11n ( AP 1252 suppo...
HiWe currently have a deployment of a WCS, two WiSMs, some 80 APs and around 1000 Clients. They authenticate with WPA2-PEAP against two Cisco ACS Servers. The ACS have valid server certificates. The Clients use all available operating systems on the ...
Hi,I am planning for a school environment where there are currently less than 20 wireless devices.Is there any issue deploying 1142 standalone AP's now, then add a controller in the next couple of years as the number of wireless devices increases.I a...
From my understanding, AIR1252 is supporting 802.11n draft version 2, are there any software updates available to make AIR1252 compliance with the 802.11n standar
Is it possible to upgrade the WCS from 6.0.132.0 to 7.0.164.0. Is it necessary to take the backup of 6.0.132.0 and restore it in 7.0.164.0 or directly we can upgrade from 6.0.132.0 to 7.0.164.0.The backup from 6.0.132.0 is compatible with 7.0.164.0 ...
Seems to be an issue with Vocera and 6.0.199. Below is directly from Vocera support. Don't yet know the exact conditions or the workaround.More discussion here https://supportforums.cisco.com/thread/2031924?tstart=0-----------------------------------...
Hello,after an Upgrade from 6.0.196.0 to 6.0.199.0 we have some roaming problems with 7921 phones on the 802.11a network. Only the version of controller software was changed. The running IOS on the catalyst 6513 switches (with 720 Sup with MSFC3 daug...
I have couple ambiguities regarding outdoor mesh solutions, (1) As per the compare page 1510 can only operate in Lightweight mode but there is nothing mentioned about the 1520 behavior, can we operate 1520 in Autonomous mode without using any control...
Hello;Can anyone ponit me in the right direction as to the following;1. I need to backup the running-config from the WLC but i cannot find how to see what the name of the file is on the WLC. Its Version 6.x2. When I upgrade to Version 7.x from 6.x do...
