Wireless

Hi All,I'm trying to get redundancy operating correctly. What I have done so far is:Created a management interface 10.136.0.13 with dynamic ap management disabled.A "ap-manager-primary" 10.136.0.15 interface on port 1 with dynamic ap management enabl...

Hello,I'm using a WLC 4400 series with 1240_APs, the number of clients is set to 12 in the WLC configuration.My question is simple, what will happen to the 13rd client who try to associate the AP??Thanks

    Dear AllI am trying to integrate the WLC with the Active directory. the wireless card on my windows professional is giving me "Validating Identity" and it is stuck there. I took some debugging on the client hopfully they are useful. I can ping th...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in ...

I am trying to setup my Cisco Aironet 1231 to have two ssids one for private and one for guest access to the internet only. I can set up the private ssid and get connected and browse the network fine. I cannot connect to the guest ssid get an ip and ...

Is there a good document anywhere that details integration between a WiSM and an ACS Version 5.0 for Authentication?

Hi,it would be fine if somebody could tell me if the following idea is practicable with wlc 4402 (SW 4.2.207.0 or any one more recent) and 1130ag access-points:- the wlc is connected to a l2 switch with it's dynamic interface (ip address 10.1.1.x /24...

Please ignore ive found the answer

Can someone explain to me why two grounding studs on this device as per Figure 2.2 ofhttp://www.cisco.com/en/US/docs/wireless/access_point/1300/installation/guide/1300hig_book.pdfThanks,Mark

Hi,This is our current wireless configuration.  Our stand-alone AP's (1140 and older 1100's) are using Windows RADIUS authentication with WPA2/AES.  We would like to broadcast the SSID for our wireless since currently we are not.I have enabled the "S...

I wonder whether there is an Access Controller that is able to output Ethernet frames as if they were generated by the mobile stations, therefore providing a bridge between the WLAN and the fixed LAN to which it is connected.

I have several AP's throughout my facility. I am having a problem where a computer does not connect to the closest AP and therefore has slow performance. As far as I know the computers are set to to connect to whichever AP has the best signal strengt...

When the Access Point (AP) and Access Controller (AC) communicate over an IP network (using UDP):1- Is the MAC address of the AP's wireless clients known at some stage by the Access Controller?2- I do not have a clear picture about DHCP (for wireless...