Wireless

Hello Netpros!I have some issues that probably most of wireless implementers faced after implementing a wireless solution. This is an actual feedback from the customer and These issues can be broken down to the following:1. The wireless Network is sl...

We have an infrastructure running 1131ABGAP's. A vendor has AP's that run on 1.4Gig. Will this interfere with our A/B/G infrastructure?

Hi,I have an AP 1240AG that I am converting from IOS to LWAPP.I have a WLC 2125 that I what to used with this AP.I see that I can associate the AP with the WLC.The problem is like this, when I tried to use a Wireless Client to associate to the networ...

Hello All, I have a trailer at a client that I'am trying to connect to the main building via a wireless bridge using two 1242 AP's. I'am trunking on the connection to each AP using dot1q. I don't mind all the vlans going to the trailer so I'am not li...

We installed the Windows SP3 upgrade on our XP system and clobbered the existing dll that had been in place with our Linksys. Now we get ApsInitialize error msgs when we boot. I think I need to download and reinstall our router software. I have the p...

Hi,I'm trying to configure a dhcp scope and as I do my tests I became more and more confused.I know that when I'm using a dhcp scope that I have to point the dhcp off the WLANs that I created to a specific IP. What is that IP? IS the IP of the manage...

Hello, Started this conversation in order to get some insight about the wireless projet i am involved from wireless experts. We have to establish 250bMBps+ connection between two islands that are seperated by sea. Islands are about 1.5KM far from eac...

The documentation on the Cisco Wireless camera only supports EAP-TLS and EAP-FAST today. Is this going to change? I have a customer that would like to use PEAP w/ MS-CHAPv2 using a corporate certificate. Will this be supported on the cameras in the f...

hey,Ive been tasked to find a way of making our non wireless label printers work. The current test model uses Ethernet so i initially looked at small wireless bridges. but there is an optional USB model.. which got me thinking.Is there a Wireless USB...

Hi Experts,I have access point AIR-LAP1141N-E-K9 and it runs on lightweight mode. Can I convert it to autonomous mode.Thanks

I have a wireless Access Point c1231G. Pretty basic setup but what I am finding is the ARP cache on this device is caching entries that are not even on the same network as the AP's BVI address. Any ideas?It affects my ability to remotely manage it.

So, I'm trying to remove some aaa servers in the page under config -> controllers -> delete auth servers.When I deleted them, it looked like they were gone, but when I checked under reports, they were still listed. I'm hoping I don't have to restart?

Hello,I'm wondering about the documented approximate range of these two Cisco antennas, that differ a lot.Can someone explain the big difference in range between these two antennas that have both the same antenna gain of 5.2 dBi and beam width 360°H...

Dear all,we deployed the first 802.11n LWAPs. In some areas where the have anumber of clients associated we get the following alarm:"Access point 'AP001d.70fa.6128' associated with controller 'Cisco_df:f8:e3' draws low power from Ethernet. Failure re...