Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I was reading a wireless document that shows a design where 3 WAPs on a 802.11b/g network for 180 users.Best practices talk about 15 to 20 users per Access Point, which is what we typically do anyway.So, my question is can the Cisco 1230 or 1240 Acce...

ryabutler by • Level 5
  • 5143 Views
  • 11 replies
  • 0 Helpful votes

Please refer to the this thread but thought it may be an idea to start a new one.http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&type=Subscriptions&loc=.2cc04897/6&forum=Wireless%20-%20Mobility&topic=GeneralSo, now I have my security poli...

We are investigating migrating from ISDN to 3G/UMTS access for a couple of remote sites and think the 3G-WIC will be a good substitute. According to the documentation you have to authenticate to the service provider through PPP to get IP-access. This...

hi to all!I'm trying to deploy many 1142 aps with 5500 controller. All aps will be near each other so it will be high ap density. To avoid interference issue i'm thinkingto activate RRM on controller and 40 mhz channel on 802.11n 5Ghz. With this conf...

uosambela by • Level 3
  • 1560 Views
  • 3 replies
  • 0 Helpful votes

Hi, i have WLC running IOS version 6 and bunch of AP (1142N, IOS 12.4(21a)JA) that i would like to shutdown at certain time. Eg. would like to have AP up at 6am and shut down at 7pm. Can this be done on WLC or on the switch where APs are connected to...

Hi,Is it safe to downgrade WLC 4402 software from 6 to 5.1? My problm is the web autentication through IAS server dosn't work - can't pass the authentication login window,it works before on 5.1Thanks.

forrestermu by • Community Member
  • 1753 Views
  • 3 replies
  • 0 Helpful votes

Hi Folks,I just spotted this on our WCS6.0MFP Anomaly Detected - 3,461 'Invalid MIC' violation(s) have originated from the AP with BSS '00:16:9d:44:65:d0'. This was detected by the radio with Slot ID '0' of the AP with MAC '00:19:aa:f5:5b:a0' when ob...

We have a primary controller (4402 - 50) and a small 4402-12 setup as a anchor for guest access. All guest traffic (for Internet access only) is sent through the guest controller - located on our DMZ. Guest users were complaining that they were getti...

tverhoeven by • Level 3
  • 11915 Views
  • 8 replies
  • 0 Helpful votes

I currently have 7 WLCs with the same Vlan interfaces defined across all 7 controllers. Does anyone know the best practice for addressing these interfaces on each of the WLCs. I currently have each unique Vlan interface assigned with the same IP addr...

Review Cisco Networking for a $25 gift card