Wireless

Good Day,I have a small wireless network with a 2106 controller and 1131 APs. We rent conference rooms to the public and had envisioned limiting access based on a user authentication against a radius server. So I was disappointed when I realized ther...

I have recently set up WDS at a remote campus. I scheduled a radio scan for 4:00am so as not to interfere with active users. The scan completed but not successfully. I got an error message regarding the WDS and I can not determine the reason. I h...

I am looking for the correct antenna for a aironet air-ap1242ag-a-k9

Hi,I have a bunch of Aironet 1230 units. I was wondering is it possible to do a sort of holding page or website for advertising before users then moved onto the web. Basically I want to setup both charged wireless access and non charged, but also hav...

Has anyone had any problems with iTouch devices not connecting to their wireless network?The WCS 'sees' the MAC address of these device but they never successfully associate. There is no further information on the WCS.Our network is a Cisco LWAPP ne...

Does 2106 wireless LAN controller support use of Etherchannel?I want to be able to aggregate several of the ports together if possible to provide more trunk bandwidth to a 3560 switch.

Greetings,I am planning a new install with 1250 APs. This structure is steel so I have to plan for both indoor and outdoor AP deployments. Indoors, I am planning to use the 5gHz radios in order to allow for more channels, Outdoor I am lookng for advi...

Hi!I have a 1200 series LWAPP. It has the default configuration which means it has configured the static IP address 10.0.0.1.How can I change the address or how can the AP discover the controller address?Ana

Dear all,I have problem with my AP. I'm using 3 cisco 1100 AP for my connection. All of the AP using one SSID named "PASO" and act as root (connected with wired LAN). From yesterday my AP always down frequently. Client can't find any available netwo...

i have 1030 out door lightweight access points connected to 4000 series controller i need to connect 2 different gain 2.4 GHZ antenna to the two rp-tnc connector on the access point one is yagi (AIR-ANT1949) and the other is patch (AIR-ANT2485P-R)...

Most of the sites have 1131Indoor and one site has 1522 Outdoor AP. All the AP's will have POE cable. We dont need Mesh technology.We are trying to evaluate between Mesh Only or Non-Mesh code for WLC. Some of the departments are low budget funded so ...

Hello, after the release of the 1250AP, I was wondering if the 802.11n compatible client adapters were planed or close to release, and if anyone had an information about that.I was also wondering if this AP had any particular CISCO features (like the...

I have Aironet 1310's connected to each other and HP Procurve 2626's on the LAN side. Two VLANs, one for data and one for voice.I cannot ping devices in the other building, but some I can. Sometimes I can ping others I wasn't able to ping before. ...

I have six of these access point that I need to put in. I have flashed all but 1 from LWAP to IOS. I have 2 Linksys/Cisco POE (802.3af) switch. 1 srw224p (24-port) and 1 srw208p (8-port). In the 24 port switch I have 2 Axis IP camera's, also POE a...