Wireless

what will be the best recommendation of AP to use for 7921 IP phone. and is there any restriction on how many phones can register to this AP and how many calls it can handle

I am at a complete loss. Calls to Cisco, working with different vendors, nothing has worked to solve the problem. This is what we see, and we see this at every single one of our hospital sites.All hospitals used to run just IOS code on their AP's. So...

Question: Do Antennas come with the AIR-LAP1252AG-A-K9 in the box or are sold separately? I am purchasing a group and do not know "specifically" if the RP-TNC antennas come with the access point.ThanksWayne

Hi guys, I have a dilemma which LAP to use inside a new building. I couldn't find a good comparison in the official documentation, so it will be of great help if somebody can give me a piece of advice and share his experience. I wonder what is the di...

Hello, our wireless web authentication is usually timing out after half an hour of inactivity. How can i increase it so people do not need to reauthenticate after 30 min of inactivity?Thanks in advance.

I need some help in determining if we are experiencing a bug or a configuration issue. Let me start by giving you details of how we are set up.We have a WLC 4404 running 5.2.178.0 at our corporate office. Our remote offices are running a 1242 AP in l...

From memory, the latest WLC software (and possibly older versions) allow channel 165 to be disabled. I can not find this functionality on the 1250 or 1140 (autonomous). That is, I want to exclude DFS from picking ch 165, obviously because I would lik...

Hi,Does it have any disadvantage to enable both interfaces at the same time?regards,

Folks, Is it possible for the SSC client to connect to two networks at the same time? it seems it does have an option for connect and connect exclusively, I am not sure what the difference is.

Hi everyone.I'm running WCS 6.0.132 with WLC 6.0.182 and I'm trying to build a Lightweight AP template to assign NAME-VLAN mapping on different AP running H-REAP.When I create the new template I setup AP in H-REAP mode and then enable H-REAP/REAP con...

Hi,attached is the output of "show country supported tx-power" command in WLC6.0.From there you can see the max tx-power for each country. From the output, u can see that most of the tx power is 20dBm for b/g. However, in the CCO doc "channels and ma...

GentsI configured an autonomous access point as being a repeater to a root one. I ping the root from the repeater and it is showing as connect. however,the wireless coverage has not been extended?what is the problem?

I downloaded the USB-Install-7921-7925.1-0-2a.exe from CCO. I tried to install it but I am getting a Microsoft Logo failure message. The instructions said I would see that. Per the instructions, you can say Continue Anyway. When I get my error I don'...

Hi,Can anyone tell the detail proceture/doc to remove software version 6 from a WLC 4400 and install a lower version of 5.1?Thank you!

Hello All, I am putting a document together and need some "live hanging" 1142 and 1250 LAP access points. I have searched the internet to no avail. I want to display office ceiling, wall mounted and drop down from ceiling 1252 APs. Any ideas where I ...