Wireless

I am trying to get hreap working with local switching with little success. I want to trunk in the remote location but no matter what I do, the dhcp addresses I receive are dependent on what the native vlan is on the port the hreap ap is associated to...

Hi, I have a WCS version 4.0.97.0, and the information of the "Client Count" Report is available only the last seven days. I can to increase the number of days in the report, for example the last four weeks?Thanks

Hy,I have a problem with low power signal receive on antenna.If I stay near to antenna the signal power is to 50%.It's ok?I have 1 WLC Controller 2112, the TX signal power is set to 1.It's possible to miss some configuration on WLC?

How can i create template in WCS to enable telnet on 200 access points..

Hi there!I was just wondering that is there any limitation of speed of wifi user moving around in the coverage area. like if someone is moving in a car in wifi coverage area, is there any restriction on speed of the moving car to sustain proper commu...

Hi,I'm looking to setup a small wireless network with 2 cisco aironets. We plan to use mobile devices with VOIP. Therefore it is essential that the devices can move seemlessly from one aironet to the other as the user walks around. I was wondering if...

Is there a way for a client on one autonomous AP in user vlan A to roam to second autonomous AP in user vlan B whilst retaining IP address without using WDS. So Mobile IP Layer 3 roaming possibly through the switch/router?The two APs are connected to...

If you have two autonomous AP's, both with the same user vlan and subnet, is there a way to block users from one AP communicating with users on the second AP.I know you can use PSPF for users connected to the same AP but need the best way to stop the...

We have a WCS version 5.2.130 and WLC version 4.2.130.0Not very familiar with it. The issue here is although the WLC is reachable from WCS, I can't seems to select a profile when we want to create guest users from lobby ambassador. The WLC has been c...

I have a WLAN that is configured with multiple mobility anchors. How does the foreign controller decide which mobility anchor to forward the traffic to? Is there load balancing across the anchors or is one designated active until it fails?Second ques...

I'm setting up a lab environment where I want to have a 3270 MAR connect to a 1524 MESH AP on the 4.9 Public Safety frequency and form an EIGRP neighbor relationship and perform routing. So far, I can get the MAR associated to the 1524, which is conn...