Wireless

Hello We're having a problem with web-authentication on our 4404/WisM controllers since we moved to software rev 5.x (currently running 5.1.151.0). With software rev 4.x our web-auth SSIDs would send the authentication requests to a Cisco ACS4.0 whic...

I have a very small branch office, with a single cisco AIR-AP1231G-A-K9 running IOS 12.3.8 JA. I would like to have them authticate using WPA-PSK and lock them down by mac-address without getting *eap/RADIUS involved. I have it configured however whe...

I have a AIR-AP1230B-E-K9 access point, which worked fine in its original hardware configuration, which included an AIR-MP20B mini-PCI radio module (802.11b standard).I decided I wanted to upgrade it to be a dual wireless, 2.4Ghz and 5Ghz access poin...

Dear All,Currently I have wcs 4.1.9 licensed for 50 AP's with a pair of wlc 4402-50s.I expect to ramp up to about 50 AP's over the next six months.I plan to build a rhel4es server to host the wcs. I can find only very sparsedocumentation describing t...

Hello AllMy working AP1200 crashed in the bottom I am seeing the lights for radioand ethernet red and status is light purple on the other hand in console mode I am just seeing ap:and possible commands are ? -- Present list of available commands arp -...

We are trying to add a disclaimer page for public users to accept and continue for our public WLAN. Need to know how to add this page, and if there is a character liimit?

I have a controller that sometimes does and sometimes doesn't prompt for memory test at boot up. What triggers the prompt for memory test at boot up?

I am trying to Power a Cisco 521 AP from a blade on a 4500 switch. The blade module number is WS-X4548-GB-RJ45V. This is supposed to be a POE blade, but when I plug the AP in, I do not get the AP to power up.

I was running version 4.2.130 on 3 wism blades. Actually one of the controllers in one wism is running a mesh code, so i did not upgrade it. Upgraded all except one (cause it won't upgrade, thats another battle) to 4.2.176.0. And now the controllers ...

Hi, we currently have one 1252 AP. It has two Vlans. One for data and one for voice. Just bought another 1252 AP and going to have similar setup.I read I can have similar SSID so that uses don't need to re-authenticate to the other AP. If this is tru...

Does anyone know if there is a MIB/OID for the AP1242's 5 minute Input/Output rates? It appears there is an entry in the CISCO-IF-EXTENSION-MIB but the AP does not populate that entry. Any help would be appreciated. Thanks.

I am running WPA/TKIP and WPA2/AES.However, the users (TKIP and AES) keep get disconnect with the error MIC failure.I thought there is a bug on TKIP to inject a frame and cause the radio went down. so we change the "config wlan security tkip hold-dow...

Hi all,One of my AP 1010 got a static IP in vlan 110 Range but Controller is in Different(default) Vlan. Due to this its not getting registerd with WLc. Anybody can suggest any procedure to remove that IP from AP.

wlc2106 + 1131AP client over pppoe successfully is open “broadcast forwarding”but on wism wlc-a and wlc-b don't PPPOEthen open “broadcast forwarding”(client in wire network pppoe successfully)sniffer wireless client found only pppoe request t...