Wireless

Hey Guys,I was wondering if a 1220 AP (AIR-AP1220-A-K9) is capable of converting to lightweight mode. The AP does B Radio only (AIR-MP20B-A-K9). On the Cisco site it says that B-Only Radio is not capable of converting to ligthweight. I just need a co...

Hi,In all Cisco documentation 1.1.1.1 is always specified as Virtual Interface IP address. Here is my concern. When wireless client gets an IP address (through DHCP), 1.1.1.1 is entered as DHCP server which means that at 50% lease time client will at...

We plan on implementing a WLC4402/1252 APs at one of our locations. Currently we use "fat" 1242 APs in selected areas and also deploy MS-PEAP using a Microsoft RADIUS server. We would like to have the ability to assign SSIDs based on Active Directory...

Dear all, I have deployed WiSM to my customer place where there are 9 floors in the building & has got 270 Aps throuout the building. Now customer is asking me to broadcast the non-broadcasted SSID to a particular floor. Any body has any clue ? I hav...

Hi allI have recently set up WDS for fast roaming on my access points, my question is, when we put usernames on each of the access points, where are these usernames getting authenticated and why do they need this to participate in the wds. do I need ...

I have setup an 1130 ag on my network without a controller. I have set it up using DHCP and configured manually. in each scenario I can only access the device via the console port. I can ping the device and ping from the device. I cannot discover ...

I am deploying a WLC4404(version 4.1.185)and using LAG connect to c6k port-channel, and c6k L2 connect to other billing system server for a wireless client gateway and DHCP, there was no authentication and encryption terminate on WLC, and all the wir...

i am using above model of access point without controller.For that we tried to convert LAP to autonomous mode but didnt get success.Here is log viewer of tftp server.Connection received from 10.0.0.1 on port 1024 [29/01 19:19:29.156]Read request for...

I am at a Customer Site whom has a Switch Fabric of about 30 switches across their Campus.the Customer is running about 15 Production VLAN's across the Switch Fabric.They also have the 1200 Series AP plugged into only one of the VLAN's (i.e., the swi...

I need to know if you can change the SSID name using the internet gui under WLANs edit without losing the config.

Hi,We have got 2 WISM,We are able to access the primary WISM from the diffrent VLAN through GUI mode,But we are not able to access the secondary WISM from diffrent VLAN through GUI mode.We are able to access the secondary WISM from WISM management VL...

Hi,I have installed a Cisco 1200 series AP and have associated three laptops at 54 Mbps PHY rate. I am doing bulk file transfer between a local server connected by a wired LAN to AP and the laptops running Fedora Linux OS.1. For the large file downl...

Hi,I need best practice advice on the folowing :2 buildings are connected trough a wireless brigde link. Both are 1300 bridges.Building A has an 2950Building B has an 3750I want to add another bridge to up my bandwidth. From reading on this site, eth...

After upgrading my 1121's from 12.3(2)JA to 12.3(8)JEC, my network monitoring no longer works. It seems clients stay listed as associated to the AP's for random amounts of time. My IAS log viewer tells me there are 2 clients associated, whereas my ne...