Wireless

I have configured AIR-AP1252G-E-K9 (lightweight)and AIR-WLC4402-50-K9 controller and connect within same LAN but AP is not showing in the controller, please help controller configuration is attachedRegards,Majid

We're running SW v4.2.99.0 on our 4402 WLC and across all of our 1242 APs; 23 total, 9 running in local mode, 14 running in HREAP mode.My understanding is, if the WLC is down, the APs will go into standalone mode whereby existing wireless connections...

For those people who have already deployed the VoWLAN using Cisco LWAPP and Cisco wireless IP phones, do you satisfied with the voice quality by using Cisco's QoS solution? I am wondering about radio upstream QoS(from client to the AP) which relies o...

Hy,until now we use only DLink WLan Components.Now we must do a Wlan Network with Cisco.We have to use 2 1240AG for an outdoor Wlan Bridge (ca. 70m).My question are,1. is it possible to use the 1240AG in Bridge Mode ?.2. For an External Antenna: must...

I have deployed a pair of 1310 in bridge mode and data are passing through OK. the two bridges are connected to trunk ports of cisco switched on both sides. In order to pass voice through the bridge, do I need to configure voice Vlan's in the 1310 as...

I am consistently having a problem with APs landing onthe wrong controller after a number of them get rebooted due to building power testing. I am wondering if anyone has any ideas on how I can make sure that these APs all associate to their primary ...

Hi, I have a WLC 4400 and a WCS 5.2. I'm receiving alarm about flood atacks and desauthentication attacks from a client. These alarms are detected by the IDS system. I'd like to know if there are any way to block this client.Thanks a lot.

Nokia E51 mobile phone cannot connect to the 1220 AP's hidden SSID. When we make the SSID to broadcast the E51 can connect.E51 can also connect to hidden SSID's of other AP's (eg.Linksys wireless router)Nokia E51 is using the latest firmware and the ...

Hi Guys, How can I add new APs to Wlan Controller? Is there any consideration/steps before adding a new one? Thanks in advance. Cheers!

HelloOn a particular place in the building we had a very low throughput on channel 1. We use the 802.11G band. Using a sectrum analyzer we found in the middle of channel 1 a non 802.11 compliant device transmitting on a very high duty cycle. This exp...

Hi.. I have 3 radios connected having a triangular interconnection. The link works fine but once video conference is started between the locations the links fails. A continues ping with heavy packet size does not hamper the network in any way.any hel...

Cisco announced multiple vulnerability in their Wireless Lan Controller for controllers running version 4.1. I am running 4.1.185. I am going to assume that all of the 4.1 versions are affected since It was not mentioned. have not upgraded as yet. Ha...