Wireless

I currently have two Linksys WAPs (one at each end of the office) that provide wireless access to the LAN but I need something more secure to meet PCI standards.Can anyone recommend a wireless device for me? I need to be able to stick it outside my f...

Hi,I have a Cisco 1200 Series AP and I want to apply security for my users when using wireless. I have also got ACS. Can anybody help me out on this.Thanks in advance.Best Regards,Rahim Amir Ali

I am wanting to securely setup two WLANs, one for Corporate Internal and one for Guest Access which will stick guests out on the dirty Internet. Is there a secure way to do this without using a second Anchor Controller in the DMZ? My budget would not...

I have installed a Syslog server in order to help troubleshoot some issues in a large outdoor mesh system. In an outdoor system we DON'T CARE about rogue Access Points. So I have turned off the rogue AP detection- or so I thought.However after watchi...

Dear Sir,I am using cisco AIR-LAP1242G-A-K9 wireless access point by console port, i can login to AP in user and previllige mode. but when every i try to access global mode its says % Invalid input detected at '^' marker. i cannt access any fastthern...

hi there, I have this wireless access point but i cant configure it. I can see the boot with the hyper-terminal windows (xp), the ip adress is 219.1.1.179 (dhcp) but i cant go on with IE or Firefox. When im on a console text (AP#) and want to configu...

Would anyone know if I would run across any issues when upgrading from a Cisco Wireless controller WLC-12 to a Cisco wireless controller WLC-50? Can anyone forsee any issues with me just copying the startup config from the WLC-12 to the WLC-50? Any a...

Here is the problem I need to solve.A family member has a dialup connection.Dialup being a 56K analog modem. They would like to bring a wireless enviroment into their home keeping this 56K analog modem in place. To be specific as possible in the conf...

Dear AllI just want to create two SSID with two different VLANs , on AP 1121G , and broadcast the two SSID , how can i do it ?i know that in my switch, the point connected to AP must be trunk , do i need to create BVI ?!!! and do i need to make ether...

Hello.Can somebody tell me, how can i configure for radius's client attach fixed group?I have 5 client's - and everyone must use for access only one group?Some body know - can i do it theoretically and if i could - maybe you know usefull link?Thank y...

Dear All, my customer has a central to 30+ remote site management solution via ISDN and works fine.Now he needs to have 3G on his central site calling to ISDN ports at remote sites, i tried explaining that its not possible as these 2 technologies hav...

Hi There,I have a general question concerning BVI & Dot11 interfaces on a 871W. I had to configure a Subinterface for the radio Interface to get he box running. This is the point which is a little confusing to me. Why do I have to work with subinterf...

My large 4 controller outdoor mesh network does not use RADIUS, so I went to the 4 WLANS and set Security>AAA to not use it. Prior to this I was getting a stready stream of Syslog messages from the different WLANS complaining about not being to find ...