Wireless

I'm securing my guest WLAN and have WLC ACL's in place and the network is segmented from everything else but I decided to run a port scan against the virtual WLC interface (1.1.1.1 for me) and ports 25 and 110 are listening. I connected to 25 and it ...

Implementing PGP whole disk encryption of laptops with Aironet CB21AG nics and LEAP configuration. Configured to pass login (AD) credentials from PGP login thru to Windows.Will not pass thru AD credentials at login until LEAP config removed. Has anyo...

Hi AllHaving installed a WLC 526 for a small school I have assumed that the ports were similar to those on the 2100 etc. However whenever port 2 is cabled the WLC dies.The setup is a flat layer 2 domain WLC with 5 aps connected. All connected via a l...

Hi,I can't get my 871w to enable WPA2 for it. I found a reference to "wpa version 2" as CLI which my rather new IOS doesn't seem to understand. So how to enable WPA2 via CLI commands? And by the way do you have a link to the wireless CLI reference?Ci...

Hello,I heard from a Cisco SE that WLCs could not manage the same number of APs if these are 802.11n APs (1250) or others.For example: a WLC4404-50 will manage 50 802.11a/b/g APs but only about 33 802.11n APs (1250).Is that true ? I really can't find...

Hi,Apologies if this is posted in the wrong discussion/forum thread.I have a Aironet 1242AG Wireless Access Point configured in Workgroup Bridge mode. The Access Point associates successfully using WPA-PSK to the existing SSID that we have here. I am...

Hi all,I have tried using access control list to block certain IPs from accessing WLC web management. I apply the ACL to interface management, but it seems like no effect at all.How can I block or permit some IPs so only certain IPs can access WLC we...

I'm using AIR-LAP1522AG-A-K9 and Enterasys switch.How should it be the spanning tree configuration in the ports where are connected the Root Access PointsSTP should be enabled or disabled?

Is it possible to set the ap speed and duplex once it has joined a controller as there is nowhere on the wlc to do this.Is there a command available after I give the ap a username and passsword with config ap username <username> password <password> <...

Hi there,is it possible to configure WPA2 on a standalone C871W? The configuration examples always talking about WPA & WEP.Any experiences? Thank you!Andy

I am having an issue with VLAN support and our guest WLAN when utilizing HREAP APs.In the past we have had VLAN support turned on on all of our 30+ HREAP APs and have seen no issues. Earlier this weak I started getting calls regarding our anchored gu...

We have 2 Cisco 1100 and 1 1200 in a hallway. At any given time we have 60 to 70 laptops connected to one of them. I am looking for a way to tune the APs to not only make them drop unused associations but to also sort of load balance the APs. The APs...

Running WCS 4.2, WiSM 4.2, 2710 4.0.32.0When I click on Monitor, Tags, I can see that it's tracking close to 150 Aeroscout tags. None show up on maps however. Clients will, just not the tags.What's interesting is if I click on one of the tags, I get ...

I have 2 BR1310 Air Bridge's configured for a point to point connection, one is root,one is non-root. In configuring QOS for VOIP for the first time, I'm looking for a best practice configuration.Behind each bridge is a 3560 switch that has QOS confi...