Wireless

Hi,we just install a solution with 10x AP1131ag controlled by a WLC.We setup different WLAN with different authentication settings (web authentication, wep, wpa-802.1x).We notice that the radio signal power is really poor and even if we install many ...

HiToday I reinstalled the image in a cisco access point, however since that I cannot use http to access it, it comes up with a screen with very basic commands. What do I need to do here?cheersCarl

I seem not to be able to convert a 1252 from LAP to Autonomous. Anyone know if any issues with performing this task on the 1252?We are using the following document.http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/l...

Any ideas what is causing this particular message in the logs of our AP's.It only seems to affect the odd user, but always the same user getting kicked off. I have tweaked the countermeasure to stop everybody getting dropped, but the cause of this is...

I used AirMagnet Planner to place 1242 APs in warehouse using 35mW and -65 dBm cell edges with 20% overlap for 7921G phones.I plan to use RRM and Dynamic Power Levels. However I noticed when manually setting the power I can choose, 1 thru 5. With 2 5...

We have over 150 AP's installed. 1. I am noticing the below type of PING times from various clients attached to various AP's at different locations. Very few locations r reporting <2ms. Reply from 172.26.5.111: bytes=32 time=106ms TTL=127Reply from 1...

Is anyone using EAP-SPEKE password authentication? I have just been reading about it and can't find out if cisco ap's will support it?SAM

Hi, I'm trying to configure a mobility group between 4 WLC's. 2 of 4 form a group and those two are the two on the same cards.The two cards are on separate subnets and each have are connected to a FW. I've opened up for UDP12222-12223 UDP16666-16667 ...

I have been asked to make some changes to a 1310 AP at a new site. When I try to browse to the device, I get the login screen, but when I put in the username and password it say :not authorized. I can telnet into it and the username and password work...

Is there a limit to the number of DHCP overides you can use per controller?

How many Cisco Aironet 1250 APs running 3x2 at 20mW under Cisco Enhanced PoE are supported on 3750E-48PD? Does it change with 3750E-48PD-F? How about X4648+E blade from 6500? Where can I find a power calculator for 3750E? I once had a customer buy 48...

Hi all, We have a wireless network, consists of 1 access point that connects to 3 workgroup bridges, for some reason when I stop a ping going to all the access points, I can no longer reach devices the othr end of the workgroup bridges.Is there a rea...