Wireless

Can the Cisco Wireless Control System be configured to send its alarms as SNMP traps to a specified trap receiver ? if so how is that capability configured ? is it thru Notification Receiver ?

Where can I download custom signatures for the WLC 4402?ThanksMatt

Hi everyone, were using EAP-TLS for wlan security. we got hundreds of wlan users, what will happen if the client certificate expires? what can we do avoid it? thanks

HiOur customer ir building new service center and asked for wired and WLAN proposal.They will have ~15 pc located in 2-3 near rooms and as Wifi we're going to offer Cisco 1252. Also they will use wifi VOIP phones.Since it's new building they could sa...

I have configured my dhcp server to provide the WLC IP address to the APs over the option 43, but the AP is not joining to the controller.I just wanted to check in the AP to see if it's looking for the right controller IP to be sure it was able to ge...

We are bringing up a building with 7 new 1252 APs. They are using inline power from a new 3750E-48PD-SF at 12.2(44). The WLC is a 4404 running 4.2.217.The 1252s will not complete a boot, and make the console prompt available. Below is the text the ap...

HiI have a warehouse with a quite simple setup.Its 2x 3750E switches and 2x 4402 controllers.The accespoints are 16 x 1252.When i drive around in the warehouse with a continuos ping running, i loose one and sometimes 2 pings when roaming.The WLC's ar...

The documentation states "A second WLC526 controller can be added to the network to support redundancy or to increase capacity to 12 access points" but it does not explain how to do it.How do I configured the second controller?How do I conect it?any ...

Hi, I'm try to find MIB documentation for the oid 1.3.6.1.4.1.9.9.521.xI can find;1.3.6.1.4.1.9.9.520 is CiscoLwappCCxRmMIB1.3.6.1.4.1.9.9.522 is CiscoLwappDot11ClientCalibMIBbut not .521 branch I'm automating WPA-PSK updates via SNMP and I can see W...

Hi.I am looking to setup wireless access to 2 of my internal VLANs. I am using Cisco 1130AG, PEAP and RADIUS for the authentication as one network is for employees only and one restricted to guests only.I was wondering which was the most recommended ...

I'm on version 4.0.219. It is working well but there is feature or 2 in 5.1 that I wan to implement but I remember when I upgraded to this version it was difficult the first time and it has been over a year.Should I wait until a slack time and do I h...

I have a question about how wireless data traffic flows between 2 wireless clients that are associated with the same AP/WLAN/subnet. It doesn't have to go through the WLC, does it?Is this documented some where on Cisco website that I can find?ThanksB...

I have configured 12 1522's using the 4400 controller to assign static IP addresses but they still seem to revert back to using DHCP after a time, has anyone else has this issue?

I have setup a NAC Guest Server to allow users to sign up guest account via Active Directory. How do I tight this into WLC or WCS?