Wireless

I am converting an 1131AG autonomous to LWAPP using the conversion tool v3.2. The conversion fails when checking input variables, specifically the text file containing the IP address, telnet username, telnet password, and enable password. I can't bel...

Hi all,My requirement is to extend wireless RF coverage to areas that laying network cables are not permissible. At the same time, i would like to prevent the adverse impact to the backhaul bandwidth like in repeater mode.I Understand 1500 mesh nodes...

Has anyone ran into this problem?We have two SSID's,one is a "guest" account that has no internal access, the other is a secure account that the PDA's need to use to connect to our Mobile Email server. The problem I am having is that they want to con...

Hi,I have a question about your WLAN Cisco 4404. I have a plan with 62 AP AIR-AP1242AGLightweight version (LWAPP). The AP will be distributed on three levels with twotechnicals offices. I want to install two POE switch per level connected with the AP...

dear sir, We are trying to setup the access point AIR-AP1242AG with wireless pcmcia AIR-CB21AG for wireless site survey. Please provide me any configuration that suit the mentioned access point for site survey usage. Thank you and your effort shall b...

dear sir, We are trying to install the ap1241 with special antenna / antenna booster that could deliver single line direction of signal. The ap1241 will serve to the end user in noisy environment with surrounded by machines. We understood that ap1241...

Hi,I have a WLC_4402/wcs and two wlan. One is private with authentication and other is for public access to web, without auth. I want to define a length of time (exemple 2hs) that a client is allowed to surf the web and after that amount of time the ...

I'm installing sites with multiple AP's. When I receive the AP's they have various levels of firmware.I have no problem updating the IOS firmware, but am also receiving two different versions of the radio firmware - 6.10.2 and 6.20.2. I haven't been ...

Hi, I have a single AP setup using PEAP with MS Win2k3 IAS/RADIUS. I would like outside vendors and clients to be able to come in and be able to access the Internet as well as a printer. I believe in order to authenticate with PEAP the laptop must be...

I'm new to AP's. Need to know if the 1310 AP can do multicasting and/or igmp. Any doc availabiel that would be helpful??

I just inherited a wireless LAN that is using 5 1230 WAP devices, all using a single SSID configured for 1) open authentication, 2) mandatory WPA key mgmt, 3) hex SSID key, and 4) cipher TKIP encryption. Everything works fine, but now I have to add a...

How can I change the password for controller based Access Points on the WCS?On the controller itself I know how it is done.( config ap username <USERNAME>password <PASSWORD> <all | AP Name>But how is it done on the WCS wher 3 controller exists?Thanks...

Hi! My requirement is to connect the access point to an Internet Router through a common L2 switch so that wifi-enabled laptops will receive public ips through the DHCP pool defined on the AP and be able to access raw internet. The Internet Router ha...