Wireless

Hi allI've been given an Aironet 1231G that I would like to set up for home use. Has anyone got any example configs for this type of setup that I could take a look at? Nothing too complicated is needed, just something simple and secure.ThanksAndy

Hi CISCO experts, I'm trying to map some traffic to a DSCP and CoS priority. The fact is that doesn't work.Steps:1.Set personal filter (myfilter)to forward from specific IP.2.Set QoS policy: my_policy --> myfilter-CoS (4).3. Add policy to 802.11g.Whe...

I want to etherchannel my Cisco 4404 to my Catalyst 6513. I create the etherchannel on my 6513, but was wondering how I create my etherchannel on my Cisco 4404? The commands are not the same as my Catalyst 6513. Any guidance would be appreciated.

This is a 1310 running 124-10b that I just got (Refurb). I didn't watch the bootup before upgrading IOS on it, however my other 1310 does not have this issue, which is running the same IOS level. Right before boot is executed on startup, I get the fo...

Hi All,I've upgraded a 3750 integrated controller and a 4402 to 5.0.148.0 (s/w and bootloader image) but the sh sysinfo ouput still reports the previous bootloader version:Product Version........... 5.0.148.0RTOS Version..... Linux-2.6.10_mvl401Bootl...

Is it possible to configure an indoor mesh with 1240 APs and 2006 Controllers?ThanksMichael

We just began looking into the process and hardware requirements to move our existing WLAN (WLSE, ACS, Standalone APs) to the Cisco Unified Wireless Network. Our APs consist of a majority of 1200 series APs (AIR-AP1231G-A-9) along with one 1300 serie...

I push the .tar but it comes back stating it still has the same revision as before...Seem to be following all the rules, just no success at it. Who out there has the trick fix.....

We are trying to setup a guest wlan with an anchor controller in the DMZ. Right now we have icmp and mpings working but cannot get any response from epings. This looks like an issue with the IP 97 traffic. My question is on a PIX 525 running PIX 6.3 ...

Hi,Anyone who is having the same experience ?When I take a call on the 7921, there is a gap of 1-2 seconds before I have the conversation and can start talking ...We use firmware 1.0.5...Thanks...

Hi to all,i need to configure a wireless link using two bridge on a single side of the link(4 bridge total),i want to aggregate wireless link with Redundant Bridging but i don't know if the bandwidth is 54mbit or is double?!?There is a hint or a meth...

Hi all, Can anyone tell me what I need to do to configure my 1240ag access points to work with my wlc using lwapp.Also how reliable are the wlc's should you use a backup wlc on each site ?

Is possible to manage webauth having a proxy enabled on the browser client?If I select a proxy on the browser and I can not access to the web page login controller.thanks.Mirko Severi.

I finally got the configuration guide to work and find my AP, but I thought I could change its IP adress from within the configurations assistant? How do I change its IP adress? I also thought I could change it to and from stand alone mode, Im not su...

Greetings,Next week I'll be conducting a survey using a 1242 lightweight AP at a two story medical building. Does anybody have some white papers, articles, or advice on how to conduct for location?I understand the triangulation aspect, and to line yo...