Wireless

Hi, We are trying to power an AP1252 with a WS-C3750E-48PD-SF switch. We apply the following commands to the switch : -------------------------------interface GigabitEthernet1/0/31 description Access Point WiFi power inline port maximum 18400 power i...

We're currently not running a version on our WLC's that supports wired guests (4.1.185) but am evaluating upgrading to 4.2.112. What is the current limitation of wired guests? Is it 5, curious as to why this is if so. My question develops out of this...

Hi, my name is Elias and I have same problems configuring CISCO871W. I need to configure same dhcp pool in the apliance and then I need to use it over the Radio interface to asign the ip addereses from the pool to my wireles client. Do you have infor...

Does anyone know the SNMP command to send a reset to an AP? model 1240/1130 would be preferred.Thanks,Scott

I am installing a 3750G with the integrated wireless controller for a customer and I am unable to session into the wireless controller from the command line of the switch. I receive the following message:Sorry, telnet is not allowed on this port!The ...

I'm working with my first 1250 access point attached to a WLAN controller. I wanted to change the channel width for the A radio, but if I choose anything besides 20MHz I get the error "Slot is not disabled or customized is not enabled". I've not foun...

I was looking at using a 1242AG and getting 4 50ft cables and antennas to attach to the end of the cable and then deploying them clockwise alternating the frequency on each zone(2.4/5.8/2.4/5.8). I guess I am wanting this radio to cover 4 zones.Will ...

Hello,3xWCS 4404 with 5.0.148 and WCS 5.0.56.After serveral days, I were not able to connect to the telnet, SSH and webfrontend interfaces on all controllers. I tried management and service-port IPs. But I get ping responses from the interfaces and t...

I have a 1200 that I need to configure with ssid "opentopublic" with no security andssid "exec" with WPA and shared keyI can get it to work with BOTH ssid all open OR BOTH ssid using WPA and sharded key. Can the 1200 do this, if so how?Many thanks

I am converting an 1131AG autonomous to LWAPP using the conversion tool v3.2. The conversion fails when checking input variables, specifically the text file containing the IP address, telnet username, telnet password, and enable password. I can't bel...

Hi all,My requirement is to extend wireless RF coverage to areas that laying network cables are not permissible. At the same time, i would like to prevent the adverse impact to the backhaul bandwidth like in repeater mode.I Understand 1500 mesh nodes...

Has anyone ran into this problem?We have two SSID's,one is a "guest" account that has no internal access, the other is a secure account that the PDA's need to use to connect to our Mobile Email server. The problem I am having is that they want to con...

Hi,I have a question about your WLAN Cisco 4404. I have a plan with 62 AP AIR-AP1242AGLightweight version (LWAPP). The AP will be distributed on three levels with twotechnicals offices. I want to install two POE switch per level connected with the AP...

dear sir, We are trying to setup the access point AIR-AP1242AG with wireless pcmcia AIR-CB21AG for wireless site survey. Please provide me any configuration that suit the mentioned access point for site survey usage. Thank you and your effort shall b...