Wireless

I'm new to AP's. Need to know if the 1310 AP can do multicasting and/or igmp. Any doc availabiel that would be helpful??

I just inherited a wireless LAN that is using 5 1230 WAP devices, all using a single SSID configured for 1) open authentication, 2) mandatory WPA key mgmt, 3) hex SSID key, and 4) cipher TKIP encryption. Everything works fine, but now I have to add a...

How can I change the password for controller based Access Points on the WCS?On the controller itself I know how it is done.( config ap username <USERNAME>password <PASSWORD> <all | AP Name>But how is it done on the WCS wher 3 controller exists?Thanks...

Hi! My requirement is to connect the access point to an Internet Router through a common L2 switch so that wifi-enabled laptops will receive public ips through the DHCP pool defined on the AP and be able to access raw internet. The Internet Router ha...

We upgraded our Wireless LAN Controllers from 3.2.78.4 > 3.2.195.10 > 4.1.185.0 > 4.2.99.0.We are implementing Vocera and they are requiring that we degrade the Wireless LAN Controllers to 4.2.112.0. Is it possible to degrade without losing any confi...

During the site survey, we used the 1230 and assigned tx power based on 100mw, 50, 30, 10, 5.. so on.. on the AP. But when we implemented the controller-based, the transmit power were replaced with 'tx power levels', 1,2,3,4... so on... I read somewh...

I think I already know the answer to this - but I'll ask anyway. Is there any available method to upgrade older 1230B APs to G radios that are compatible with the 4400 WLCs? We've got 30 in use and that's big bucks to chunk them all in the trash and ...

Hi allI've been given an Aironet 1231G that I would like to set up for home use. Has anyone got any example configs for this type of setup that I could take a look at? Nothing too complicated is needed, just something simple and secure.ThanksAndy

Hi CISCO experts, I'm trying to map some traffic to a DSCP and CoS priority. The fact is that doesn't work.Steps:1.Set personal filter (myfilter)to forward from specific IP.2.Set QoS policy: my_policy --> myfilter-CoS (4).3. Add policy to 802.11g.Whe...

I want to etherchannel my Cisco 4404 to my Catalyst 6513. I create the etherchannel on my 6513, but was wondering how I create my etherchannel on my Cisco 4404? The commands are not the same as my Catalyst 6513. Any guidance would be appreciated.

This is a 1310 running 124-10b that I just got (Refurb). I didn't watch the bootup before upgrading IOS on it, however my other 1310 does not have this issue, which is running the same IOS level. Right before boot is executed on startup, I get the fo...

Hi All,I've upgraded a 3750 integrated controller and a 4402 to 5.0.148.0 (s/w and bootloader image) but the sh sysinfo ouput still reports the previous bootloader version:Product Version........... 5.0.148.0RTOS Version..... Linux-2.6.10_mvl401Bootl...

Is it possible to configure an indoor mesh with 1240 APs and 2006 Controllers?ThanksMichael