Wireless

Hi,we try to setup a Backup Controller over a WAN Link. I know that the 100mesc is one of the limitations.But what happens to the Routing and DHCP for the client if the Controller is been far away ?Did i have to change something in the Routing Config...

I'm running into an issue where my client connects to a specific wlan using EAP-FAST as the EAP method and am using automatic PAC provisioning, initially everyting is working fine but the connection strength goes from excellent, to poor, then to netw...

Has anyone successfully ssh'd into a 2700 location appliance? I get prompted for a password and enter the root user password I set up during the initial installation without any success.Thank you for any feedback.

Has anyone ran into an issue accesing the service tab to display the service summary page? I ran into this issue while configuring the wap through the browser when suddenly the service tab will not display the services summary page. System Software V...

Hello everybody,I have to ask some easy questions about Wireless WLC implementations.I want to deply a WIFI network with 3 WLANS/VLANs + 1 wired-only VLAN for management purpouse. The access-point and the WLC should be connected to a non cisco layer ...

Hello, we have just deployed an SSID of hVoIP and applied CAC and QoS. It works well. We have a "data" SSID of DATA.Is there a way to only allow the Cisco wireless phones to authnticate to this SSID and block, say laptops or other WiFi phones, from a...

Hello,is it possible to replace the standard lwapp ssc against one of our company CA-certificates to allow the wlc to check the correctness of the aps certificate ? (button under security/aaa/ap policies -> Authorize AP agains aaa on the wlc) Is ther...

I have a fairly large wireless rollout of access points at my hospital's main campus and then I have 41 remote sites that have approximately 3 to 10 access points at each location.My problem is this, I just converted one site from 9 autonomous access...

I have been using RLDP and setting up Rogue sniffers on a trunk port for some time now and it has been working fine. It can detect the rogues on the wired network however when it does detect those rogues it shows the mac address of the wireless radio...

Hi All,I will installed two APs 1522 for mesh network on poles, is it necessary to buy the hand strap tool AIR-BAND-INST-TL and how many ? In the doc, there's a ref too for a Band Hand tool AIR-BAND-IT-TOOL, what's the difference ?Thks for your respo...

Hi,I am setting up a 6509 with a WISM controller module.When i "loose" one controller, the AP will failover to the second that is part of the mobility group. During that failover, the radios will go down disassociating any client connected...Here are...

Hey all,I'm deploying a WLAN composed of one 4402 controller and about 15 wireless access points. Is there a way I can limit the amount of clients per access points? Say to about 20?

Hi All,I would like to know if "IPSEC over TCP" is an issue for LWAPP communication? I am currently running Easy Vpn server & Remote using IPSEC over TCP. Trying to place a LAP on the remote site, registering back to my WLCAs i read on the cisco doc ...

I'm familiar with the procedure for bridging multiple VLANs between two Aironet bridges (e.g. 1300 series) over a single SSID, but I have no idea how it works, and that really bugs me.Since frame tagging a la 802.1q isn't part of the WiFi protocols (...