Wireless

I am setting up a wireless network for the first time and I am a bit confused about how the wireless clients obtain thier ip address. do they obtian thier ip address from the dhcp server on the wlan interface on the controller or is the wlan interfac...

Our wireless network has gone through several changes over the past year. We now only have 3 wlans. I usually created AP templates and enable WLAN override to select which APs get which wlans. WCS does not however seem to be updating with the WLCs. M...

Can I have a single SSID assigned to H-REAP sites and to my HQ site? The HQ site would not need H-REAP and runs mainly 1230 APs so it's not even possible.--Patrick

OK, here's the issue :Customer site - 1130 series LWAPP AP's, WLC 4400 series with 4.2 release, WCS with 4.2 release.ACS SE 4.0 and a second ACS SE with 4.1Windows XP clients using WZC, all settings for connecting to WLAN are set, and everything work...

hi,I support the cisco wireless network at a city hospital and have been interested to read about OTAP which seemingly is a method of distributing updates and content to wireless devices.we run cisco 7921g`s and would like any feedback or ideas as to...

I have a 4402 WLAN controller with 4 wlans setup on it. One of them has open security for "hotspot" type access. Users connect and when they open their web browser they are prompted by a login page for authentication. The user accounts are setup on t...

I currently use a WGB352B configured to attach to an AP1231G for a remote buildings connectivity. The buildings are about 1200-1500 feet apart. I have Yagi antenna's on each side. Signal quality typically ranges 70-80%, but strength is between 30-55%...

Adding the 1250 to our lab, having problems getting clients (HP tablet PC's) to "see" the AP. Currently using Dlink DWA-652 cards, they see local SSID's and MAC addresses, but not the 1250. I can see the 1250 on the controller and WCS.Any suggestions...

I have a 1310 that is getting a "system encounter an error initializing the ethernet port" on startup. It says to interrupt the boot seq and do a ether_init and then bootI have done that but it still comes back with unable to initialize ethernet.Is t...

Hi,Mine is a first WLAN deployment for our new office. The hardest part is to decide which AIRONET equipment to buy and how to design. The office has three floors plus a basement. There will be about 50 users to be connected. We shall be using 802.11...

Hi,We recently had a partner configure our wireless deployment based on two 4402 controllers located at the headquarters.This partner configured WLAN bound to Management interface (not dynamic interfaces) and said that this is needed.I serious doubt ...

Have a scenario where a 3rd controller is to added at a site. What pit-falls do I have to look forward to if I copy the config from an active controller to the new controller and the add it to the network. All of this assumes that before connecting t...

Im running the attached config on a AP350 access point.The AP350 gives out IP addresses via DHCP but does not connect to the internet.If I give the clients static addresses all works fine.Can anyone tell me where im going wrong.

First off, my wireless is deployed in a noisy environment (tire manufacturing).That being said, whenever I run an 802.11 MAC counters report in WCS it shows the number incrementing. I know one way to clear the counters is to reboot the APs, but that ...

I have been using my WLSE device for LEAP authentication however am in the process of retiring it as I deply more and more WLCs. Which Cisco devices can authenticate LEAP requests?I have several 4400 Wireless Lan Controllers, however not sure they ca...