Wireless

Hi! I have a 1200 series LWAPP. It has the default configuration which means it has configured the static IP address 10.0.0.1. How can I change the address or how can the AP discover the controller address? Ana

Is DFS the only option on all regulatory domains for 802.11a? The ETSI versions also lacks support for 5.745-5.825MHZ. Theese channels are allowed in several European countries!

I have a 521 WAP on my network. It got a DHCP address and I can PING the 521.I created a community and told it to Discover using "a single device by IP address". It fails to connect. I am trying to roll out six of these in standalone mode. Any help i...

Hi !Just upgraded some Aironet 1230 and now I miss the following commands : antenna receive XXXXXX antenna transmit XXXXXCan't find anything regarding this problem in the release notes.Anybody else seen the same problem ?

I have 6 Cisco AP 1131's running LWAPP and a 2106 WLC. Its a pretty basic setup-no VLANs-WEP security. There are 3 MAC's in our office. All 3 run Parallels, MAC OS sw that allows the MACs to run multiple OS's and switch the networking between them vi...

What are the modes available for WPS capable wireless device?

Dear sirI have one Aironet 1200 access point and I wanted to reset it password but unfortunately my IOS have found problem and it cannot work and I want to load the IOS again , according to the manual I did as follow but there is some problem would y...

So I've got a 4402, which I've configured and everything there should be good to go. I associated a new 1131AG this morning. I used DHCP to give out IP addresses, and manually input the WLC IP Address into the AP via the LWAPP command. The AP has sin...

will I be able to achieve throughput of around 100 Mbps in point to point bridge mode as 1250 series supports n draft ?

I have a Dell Inspiron 8100 with a TrueMobile 1150 PC Card. After some hunting I was able to find and install the appropriate Windows XP driver and utility program. I bought a Linksys WRT54GS wireless router, and I succeeded in getting it set up so t...

Greetings,I recently purchased a Cisco 526 Express Mobility Controller and 5 521 AP. I would like to set this all up using radius and would like to know a good way to implement with security in mind.I am having issues with getting the controller to o...

Is it possible to assign to different SSID's on an 1121AP? I would like to have both SSID's apply to the local subnet. However, one SSID would use one WEP key, while the secondary SSID would use a different WEP key. I've configured both SSID's in the...

Does anyone happen to know if the AIR-LAP1242AG-E-K9 AP (it's the AP used in Europe)is coming at the end of life?Thanks...

Good afternoon, have a customer site that has some 1240AG Access Points throughout their facility. Each one's software version is 12.3(7)JA2. Each access point is assigned a static IP# of 10.16.0.10 - 10.16.0.13. I can access each via web browser usi...