Wireless

I presently have a 12 mile point to multi-point system using an old Ap350 AP and WGB350 and WGB1310 clients. I would like to replace the AP350 with an outdoor unit but don't need the mesh capability. Would a Aironet 1522 be a good replacement and be ...

does anyone know if i can use dual RG-6 cable at length of 1200 ft (300m)between the Power-Supply and the AP itself?or for that matar what is the max length of this type of cable to be used in this situation?

http://static.scribd.com/docs/41wye5kbwsbgb.pdfusmc field antenna guide in pdf format

I change the MAX Association number of the clients using SNMP. When i do this the AP disconnects all the clients! Is it necessary or i have a wrong firmware version.

Hello,I have used the command snmpset to change the properties of my ap.After that, i got the following message:Notification: Interface Dot11Radio0, changed state to reset.When the AP resets its state, all the clients are disconnected. How can i avoi...

Can a controller reach a radius server through the service port?

Hi,I'm looking to deploy a WLAN network using AP's, Radius and Certificates.Do I need a WLAN controller? If so, what does it perform.SD

I would like to know what is the difference between the Wireless Lan Controller and the Wireless Controller System.Need I WLC if I want deploy WCS.Can I use WCS without Wireless LAN Controllers?.Thanks

I have a 4400 configured with a private wlan and a number of 1100 APs on 3 subnets. The APs get the correct IP but clients connected get an IP from the same subnet as the controller.i.e.subnet 1 10.1.1.1-254 (4400 + 4 APs - APs & clients get 10.1.1.x...

I have to WLAN one is in the same subnet as the managment and ap-manager which works fine. All the AP's are in the same subnet as the managment interface. I have create a second interface on a different subnet and have the second WLAN mapped to it.Al...

So has anyone yet jumped up to this release? I'm on 4.1.190.5 and wondering if the improvements are worth the outage it causes.I am hoping thay they have Secondary Backhaul working anywhere near how it should yet.

Guys,anyone know how to get a AP back online if it continues to flash?i've tried to reboot the AP - but no luck!!thanks..

Hello,I am looking for a solution where by I can provide wireless converage (wireless carpeting) over 3 kms. The situation is as below:1) I have a huge consturction site. (3kms or more and its a desert). I want to provide wireless network from a base...

when AP names are updated on a WLC, how to propagate the changes to the WCS? WCS still shows the AP names as MAC addresses instead of user-friendly names that were set on the WLC.

I am usint the site survey option o nthe 7921g phone. It will display the channel, bssid, rssi, and CU. I am trying to track the BSSID to a particular access point. I thought it was a part of the mac address but it is not. The mac address of the acce...