Wireless

Does anyone know if OEM Airespace APs (Airespace 1200)are compatiable with code 4.1 or higher on a Cisco 4400 WLC?

I am running a 4402 controller, wireless location device and WCS. I have setup a Guest Vlan that is restricted with a ACL. Is there a way to restrict / turn off the Guest Vlan during certain hours of the day? Either through the WCS, controller or our...

Hi All,Our WCS has been deployed and running for more than a year. Recently we have added more controllers (4 X 4404) to be monitored by the WCS. The WCS is running 4.1.91.0 on RHEL 4 update 1. The WLCs are running 4.1.185. We noticed on the Network ...

I am trying to set up a Aironet 1100. I enter the mac addr. into the IPSU and get a error - device does not answer. I've reset the device, ng. Tried 2 different computers, ng. I cannot get to the config. page. Any ideas?

Hi,we are currently implementing Cisco ACS Self Signed certificate, for PEAP-MSChapv2 Wireless Access, where we have our Cisco ACS linked to the Microsoft Active Directory. So, we are distributing the Certificates through GPO's.What can be the risks,...

Guys,I cannot figure out how to enable management over dynamic interfaces on a wlc 526. I can find the management over wireless on the GUI but not the option to enable the above mentioned one. If I try by CLI the only option after "config" is "advanc...

Hi, I got two computers and an AP. I have configured my AP with WEP 64 bit encryption, but on my one of the computer it say 40 bit or 128 bit. Do you think I can config all three with 128 bit encryption, and it will work?ThanksFayyaz

is it possible to configure aes-ccm on aironet 1220b access points

A few questions about starting a mesh network..What all do I need.. Also will the cisco equip work with other 5.8 mesh network systems?

Hi,We're implementing an ACS SE 1113 appliance running ACS version 4.1. We're a little confused over the CISCO workstation object and whether its actually needed. If it is needed, then does the Remote Agent reference the object via the LDAP name or v...

Hi,I have a few questions about the WLC2006 CLI:1 - Client statistics can be displayed on the WLC2006 with the command "show client detail <MAC addr>". I don't find in the documentation how to clear these statistics.2 - Comments are generally welcome...

Ok,On an areonet AP, the rp-tnc connectors are parallel to each other, allowing for the ability to run diversity with dipole antennae, duckies for example.What if I wanted to do the same on a 1020 AP? Are the external connectors mounted in such a way...