Wireless

Hi - This is my first time using the 526 controllers. Here is the scenario: Two buildings connected via 1310 wireless bridges (one for voice, one for data). One building will have 6 521 APs, the other will have 1. I can't find documentation any where...

Hi,I am looking for a solution to provision wireless access to employees( internet and LAN access) and for "guest" (just internet access) from one central wireless control platform. Can you guys please suggest me some ideas?

I want the automatic redirection to the login page work when a proxy is configured in the IE parameters.I used the command "config network web-auth-port 8080", but when I open IE, I'm not redirected to the login page (the DNS request works).When I do...

Hello all. I've got two questions related to wireless QOS in a UWN world:1) A QOS profile is associated with a WLAN. Is it possible to diferentiate traffic within a single WLAN? Can I assign the gold profile to one DSCP value, and the silver profile ...

Dear Sirs. I have installed AP1242 access point in rather harsh environment indoors. The AP is in 3 meters below the ceiling of the warehouse, however, the ceiling is not completely sealed. I've installed the AP on the vertical surface, so the upper ...

we are in the process of upgrading the wireless network in the office to use the Unified solution. We have converted the WLSE to the WCS and now in the process of configuring the WISM cards. 1st off we are having an issue with the console connection ...

Is it possible to have multiple WDS servers in one subnet?I was wondering if entering an IP address at the option "Specified Discovery" for all APs could make it possible to have APs register themselves to a specified WDS AP in one subnet? My client ...

I know general Cisco design shows WLCs connected on the internal LAN and then connected to guest anchor in DMZ over EOIP tunnel. Our security folks have a problem with this and asked if it is possible to have all the WLCs in the DMZ. They are worried...

Hello,Cisco 1100 :First config. : no vlan with WEP for access networkBut when you create a vlan for wpa-psk with simple config (no server manager, no radius, no eap), have you to modify the other peripherals networks (router...).For example to declar...

I have two 1220 ap's plugged into an unmanaged switch. I'm able to connect to the ap but I'm unable to receive dhcp info from our server. We have a 2950 switch that feeds to one of the unmanaged switch's and the other unmanaged switch is plugged into...

Actually I have the following X-File: Since several firmware releases our 4404 WLCs report two Rogue APs as on our network. But they are definetively not on our LAN. They are in neighbour buildings but they belong not to our university. The buildings...

I have 2 sites with 2 IOS AP's each. I would like to use a WLC to control all 4 AP's. I want to have the same SSID at both sites, but have 2 different DHCP servers, one for each site. The reason that made me think this might be possible is that I hav...

Hi Friends,I have one wireless lan controller in my network and 21 APs.Also i have LDAP server in my network.I manage all the user login database on LDAP itself.\On WLSE I want to configure the LDAP parameters so that it will communicate with LDAP fo...

Hi - I'm unable to get the 1310 Bridge LED's to act as aiming tools during install. I've followed all directions, I've googled and noodled, but can't figure out what I am missing. I'm thinking the alignment tool in the 1310 should act as a "stud find...

Hi, I have some difficulty to make a wireless bridge totally transparent.A wireless bridge created on two AP1242AG Access Points to connect two physical networks. Access points are configured as root-bridge and non-root bridge.Bridge SSID is up and r...