Wireless

In order to fix some issues related to CSCsh69985 Cisco had our client change the 802.1p value for the Platinum QoS profile to ?7?.From what I am reading this changes the 802.1p value for the LWAPP tunnel from the WLC to the APs. However, what happen...

I've been tasked with setting up a temporary wireless network for a conference. I've done this event in the past with various older 802.11b technologies, but the con keeps getting more people with wifi devices. Out of the 500 people in the venue, I'd...

I'm told by Cisco that H-REAP does not support client load-balancing. We have a situation where we want to deploy LWAPPs using H-REAP into a conference room where training would take place.Any suggestions on how to overcome the inevitable slowness th...

We have response times that is between 1 to 100 ms on a site. And they change rapidly have try to see why with spectrum analyser and the signal goes up and down very quick but with no interference. The building is 13 floors high how will the automati...

hi, i am using antennas of 5dbi for some aps and 2.2dbi for the others aps. so i would to know if i should configure in the controller the antenna gain? or the controller does this automaticaly?

What are best practices in consideration to wireless network design? I have a WLC 4400 and 1200 AP's that I want to deploy to replace my existing wireless network. I am researching the best network design for implementing a secured wireless infrastru...

Has anyone had any issues post installation of this version. Specifically, APs randomly disassociating/associating as a result of a max re-transmission event.

Has anyone had success with a 1242 lwap with a 4402 switching the AP mode to bridge? I'm getting an "error in setting AP monitoring mode."

hi evrybody can someone help me how can i activate the roaming with the customer so that it whom been able to connect to another AP cisco 1310GTHANKS FOR YOUR HELP

What I mean, by "Industrialized," is, has anyone deployed these phones to a manufactuing shop floor environement? Could you hear the phone ring? Could you feel it vibrate? How about when your talking on the phone, can you hear the other end ok? Pleas...

Hi folks, I just got a Cisco 1240AG Access-Point.There are other access points around and I do not want interference from other AP.If I have access to CLI commands, how can I change the frequency on this AP? Is that recommended?

Hello!Is there an mesh function in Aironet 1130GA , and how do this work with WLSE?Edit: Changed title

I WANNA INTEGRATE CISCO AP WITH CISCO ACS USING MAC AUTHENTICATION ..PLEASE CAN SEND ME THE REQUIRED CONFIGURATION GUIDE....ARINDAM

I bought a NAS using Samba and FTP server and plug it on one ethernet port on my 877W router. I can see the shared drive on every computer plug in to my router but can't see it on my wirless laptop or clients. I can see all devices (printers, SAT rec...