Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Dear All, when I set up a new Aironet AP (1242 or 1310) there is a section AP Authentication (below Security). Can anyone explain me how the AP Authentication works and which device authenticates the APs ? Can this be done by the local authentication...
Hi!I have a network consisting of 22 autonomous Aironet 1120G accesspoints. Is it possible to upgarde these to lightweight accesspoints for using with a Cisco WLAN Controller?
Hello all,i have bit confusion, Linksys Access Point comes at which layer of TCP/IP....Thanks,Dhaval Tandel
Hi,Can you guide me to the best Wi-Fi sniffer software?Thanks in advanceAbd Alqader
I am trying to convert a LWAP to Cisco IOS and the tool wants to know the Admin Name*? This is a factory radio sent to me as LWAP. I cannot seem to find out what the Admin Name is, I have tried Admin and Cisco not sure what else to try.
We currently use the Intel 2915ABG cards but would like to replace them with something that supports CCX without the Intel PROset software. I know that the Atheros cards support CCX3, but we are looking for something that supports CCX4 with only the ...
I have a customer who keeps drilling us on going entirely wireless. While we keep talking about shared RF spectrum, shared bandwidth, etc they remain unconvinced.Can anyone point me at information on Cisco.com that talks about this?
Hi All,I've upgraded WLSE to WCS using the CD's supplied by Cisco, and that all went swimmingly, however they supplied WCS v4.0, and I need to run v4.1. So, I've downloaded the 4.1.83.0 bin file, and burnt it to CD, and have also uninstalled the old ...
Hi,Sorry if this is a daft question or in the wrong forum but I am pulling my hair out with this one. According to the spec the 857w router does support WPA2 but I can't for the life of me get it to show up in the configs anywhere. If it does support...
I followed the directions according to the configuration guide 12.3(8)JA but the repeater never connects to the root AP and I notice the radio is "disabled" after setting the AP in repeater mode and it will not let me enable it. Any ideas as to why I...
Hi all,I'm having some problems with a bridge shot between a pair of AIR-BR1410A-A-K9's, sometimes to the point that I can't get logged in (telnet) to the near root-bridge and users at the far end end up dead in the water. I have no trouble getting i...
I have a new 1242 and I can never get to a config prompt. I have reset the ap and I still get the same issue. All I get is the following below.*Mar 1 00:20:26.798: %LINK-3-UPDOWN: Interface BVI1, changed state to up*Mar 1 00:20:27.799: %LINEPROTO-5-U...
I tried to upgrade a brandnew WLC2106 from V4.0.206 to V4.0.217 using the fileAIR-WLC2006-K9-4-0-217-0.aes and once the file is downloaded I receive an error that this is not the correct image for the 2106 . On CCO I do not find specific files for 21...
Is there a way to recover/change an admin password on a WCS server, or is the best bet to uninstall/reinstall WCS. I can't find any documenation on cisco.com mentioning password recovery on WCS. Thanks!
Have trawled what docs there are and cant find out if the RADIUS accounting messages from the 4400 include the name of the lightweight AP handling the user session.I'm guessing there might be a new Cisco VSA for it.Anyone know?Thanks
