Wireless

The quick start guide for 4400 wlc states "Cisco recommends no more than 25 APs per port". As far as I know, the controller has one single AP manager interface mapped to one of the ports, which all APs must connect to. Using a 4402-50 wlc and layer 3...

I just purchased a Cisco 1242AG to use in the conference room. Do I need to place antennas on this unit?Thanks from the old man

Hi,I am trying to upgrade my wireless basestation to the latest release of software from 12.2(13) when trying http and the tftp options it failes everytime, cant get them to upgrade.anyone any ideas,

my customer wants to know what are the advantage of using the 1310 as AP vs using 1242 AP for outdoor users. We know that we can wired the 1242 internally within the building and extend the antennas to outdoor for outdoor users. I know that the 1310 ...

Hi,I have a second hand air-lap1242AG (basically aironet 1200series - configured to lightweight mode). I would like to configure it in a small business. We have a Linksys WAG354G (Wireless-G ADSL Gateway), which has 4 ethernet ports. It has a really ...

Hi there, Does anyone know, why the CP7920 send aprox. every 60 sec. an ARP Req. Packet Src: MAC Cisco 7920Dst: ff:ff:ff:ff:ff:ff-------------------------------------------------------ARP:Sender MAC: MAC Cisco 7920Sender IP: 0.0.0.0Target MAC: 00:00:...

Hi,I have a WLC4402 and ACs 4.1I am trying to implement EAP-TLS. But the clients are not associating with the APs. The log shows that the Association has failed due to unspecified reasoncode 1.When i implement PEAP in the same setup i am facing no pr...

Hi,I seem to get these messages from an 1130 LW, using a 4400 as the controller. Exactly every 20 minutes for the wholes days. Im around 10 meters away from the AP, and every now and then I get a low signal, then the wireless disconnects and reconnec...

Hi all,Anyone know that how can the IE display pictures in WCS? Even I enable all field in Security and Advanced in the properties dialog of IE6.0 in Windows 2003, the picture still cannot display in the page of WCS. And the certificate issued by WCS...

I have a client that has a network built out of Cisco Aironet 1200 Series APs. Local authentication is required and everything else seems to be pretty standard. I have not been able to get the MACBook to authenticate to the network. I got a Cisco PCM...

Hi I am currently building a mobile trailer for wireless deployment with an Aironet 1500 AP. The unit will be powered by battery and solar panel. Can anyone advise the power consumption of an Aironet 1500ThanksMerv

Hello everyone,I am trying to get an idea of mounting the AP in the ceiling. I do not see any picture showing how it is done. I need to buy 4 Access points and mount them in the ceiling in our companys' office. I see some aluminum brackets that came ...

I have several Aironet 1100 series APs and everything works fine. I would like to decrease the signal so it could only be reach in certain distance or area. Is there a way for me to do this?

Recently my company has started doing lots of wireless surveys. The survey kit consists of a battery pack several AP's and antennas and what I belive to be a steel speaker stand as the survey pole. Once you have the AP and batttery pack on this thing...

whith deployment guide do we need to follow, the deployment guide for wireless location services uses a high density of access points (interference) and the VoWLAN deployment guide uses a low density of access points?will VoWLAN work in a wireless lo...