Wireless

I was playing around with the config of a Cisco 1030 from my WLC, and set the mode to "bridge". And hit the Save button. Now the 1030 endlessly reboots itself, and the WLC no longer sees it. Is there a way to reset to factory defaults without the WLC...

I have just installed a Linksys WRV54G VPN router and I am trying to set it up securely. At this point when I access it, the Windos message is that it is an unsecured wireless network. I was hoping to have a use be required to supply a user name and ...

we configured a 1242 AP with a static IP that's on the same subnet as the rest of our network. we were able to finish configuring the AP-SSID, etc via web-ing into the AP when it was plugged into a network switch. We then powered it off and took it t...

Has anyone configured a 11xx series AP with 3 SSID? and more importantly can I have 1 SSID WEP and the others WPA? I have a client that wants to use VoIP phones that only support WEP, but I would like the guest and LAN SSID VLAN to use WPA...Any comm...

Dear All,I wanted to ask whether AIRANT-24120 or other high gain bridge antennas can be used to provide Access point capabilities with 1300 series AP.My scenario is that, that i wanted to give roaming services to my WIFI clients in approx 15km range....

Hi, Im looking for possibility to configure Cisco Access Points for PPPoE and VPDN anybody knows pls reply to [email protected]. tks

Hello Everyone, I am using two 1310 bridges in a root / non-root setup. The switches on both sides of the wireless bridge were setup to trunk native vlan 253. Each wireless bridge also had vlan 253 setup as a Radio and Ethernet Interface. In this con...

How many clients can each access point support. I cannot find any documentation. Thanks for your help.

Hi,I posted a question a week or so ago about setting up an 877W with wireless and VPN back to headend site. The requirement is for the remote site (5 + users) to VPN to main site but have wireless locally with authentication via PEAP into headend si...

Hi thereWe have a wlc 4400 and i have pulled the log for the error codes/events off it.I need to decode these messages now to understand what I am seeing.Where can I do that ?Is there a decoder/debugger for these messages ?for example..Fri Feb 9 03:4...

I have a netwok with 1240's with fw 123-8ja2 WLSE:2.1330 AP'sAll AP's are registred to the WDS. The WLSE properly authenticated to the WDS (setting registry keys). All AP's are managed by the WLSE. Radio management is switched on on all AP's. When I ...

Greetings:We are using Radiator 3.16 (http://www.open.com.au/radiator/) as our Radius server. Its working fine for VPN authentication.We're trying to use 802.1X on our wireless network. Does anyone have a Radiator config for using EAP-PEAP? We can't ...

We have two 4400 WLC Controllers on our network using ACS for authentication. For over a week now one of the controllers is comtinually sending the following messageAn Alert of Category Switch is generated with severity 1 by Switch PHMDP01_WLC4404_2/...

Okay, here's the issue I'm having. I have a couple of LAP1310G access points. Obviously, they're of the lightweight variety. However, it comes to light after I get them (and can't return them) that I need autonomous AP's, not lightweight. The big pro...