Wireless

Hi I have four APs on a single floor. with chanels 1,4,7,11. The Clients are EAP authenticated .My problem is that some of the clients ( at some point of time one or the other user reports) go for re-authentication. The Server is placed globally wher...

Hi All,We are getting ready to deploy AP's in our warehouse and they will be mounted in quite inacessible heights once installed. As well as setting up AP redundancy I had an idea to run two CAT6 cables to the AP, one for the network and one for the ...

I'm trying to assign a IP address to my AP. I connect the AP directly to my computer (no DHCP). IPSU doesn't work. I switch my computer's address to 10.0.0.2 (AP is reseted to the default values) but still can't even ping the AP with 10.0.0.1 (should...

Would someone explain the difference between these two commands, their effect and where they are used in the config?

When have approximately 30 AP1231G installed using authenication and some are having a problem with connectivity. The signal strength is usually excellent but the cloud in windows says "either little or no connectivity". They all have the same softwa...

I need to clear out the rogue access point data from WLSE. There are now in excess of 30,000 rogue access points listed and Location Manager is struggling (running out of Java Heap memory). Any idea how to do this? Deleting them one at a time is goin...

Hi - while flashing AP firmware to 12.3.2JA2, the upgrade failed and somehow deleted the IOS image on the AP as well. Now the AP cannot boot and gives this message: "The system is unable to boot automatically because there are no bootable files to ...

Hi, this mornign at work i've done a mistake configuring an Access point Cisco Aironet 350.I was upgrading the firmware of my access point, but something was wrong and now, when i turn on my access point, it has all the three lights amber color.I thi...

Having problems with a Symbol 802.11b handheld connecting to the 802.11g radio of an AP-1200 using 12.3(2) firmware. When 1, 2, 5.5, 11 Mbps data rates are enabled on both the station and AP and only 5.5 is set to basic, the station will not associa...

Well...i need help to configure tha access point as a repeaterand i configured it as Reapeter already but constantly the network is going down.. and its said that it wasnt authenticaded for its parent...and also i cant change tsunami name.. but if i...

We just purchased several 1310's to connect buildings together. The users will connect thru lan interface on each AP. There will not be any wireless users. The only wireless access should be the AP's. Our question is what is the best way to configue ...

Hi Sir,Can Lifebook T4010 Tablet PC support LEAP?Thank you.Delon

Hi All, I am trying to get the EAP SIM client Supplicant (Installed on laptop using Cisco 350 adaptor) which is connected to Cisco1230 AP and Radius Server. I know this cofiguration works because I have tested with Gemplus EAP sim client. But on cis...

I have a cisco wireless client associated and authenticated to a cisco 1200 AP. In the AP's GUI interface, I perform the Ping/Link test. The ping test results are 100% success. When I do the link test, the Link Test Output reports "No response fro...