Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Dear Support,I have a satellite (30 users) site which has a Guest WLAN running on an 1100 terminating on a PIX 515E, the 1100 is also acting as a DHCP server for the Guest WLAN.They have asked us to install PEAP, Microsoft RADIUS and/or IAS to implem...

aoshea by Level 4
  • 919 Views
  • 2 replies
  • 0 Helpful votes

what happened with this message:Inconsistent device state found: Device "APxxxxxxxx": ifIndex=2, MAC=00-xx-xx-xx-xx-xx: "IEEE802dot11-MIB dot11PhyOperationTable.dot11PHYType unrecognized the next notification is: StateChange: DeviceStateValidation is...

joseavalero by Community Member
  • 736 Views
  • 2 replies
  • 0 Helpful votes

is it secure using secure network and open network on the same AP (with vlans)?i would like to use it with trunk connection to my switch and broadcast 2 ssid's - 1 for secure network and the other for public internet.

amisu by Level 1
  • 639 Views
  • 1 replies
  • 0 Helpful votes

We have a WLC 2006 that is setup to distribute IPs to wireless clients using the internal DHCP server. Occasionally, wireless clients can connect to the APs (four 1131AGs) but do not get IP addresses assigned.Rebooting the WLC temporarily fixes the p...

enovin by Community Member
  • 931 Views
  • 3 replies
  • 0 Helpful votes

We have a WLC 2006 that is setup to distribute IPs to wireless clients using the internal DHCP server. Occasionally, wireless clients can connect to the APs (four 1131AGs) but do not get IP addresses assigned. Rebooting the WLC temporarily fixes the ...

enovin by Community Member
  • 827 Views
  • 3 replies
  • 0 Helpful votes

I'm being tasked with upgrading one of our warehouses from autonomous to LWAPP AP's. (both Cisco). The challenge is that I'm being asked to install new equipment and keep both environments active during a two week UAT period.I'll be using unique SSID...

RDowey by Community Member
  • 944 Views
  • 3 replies
  • 0 Helpful votes

I'm using an aironet 350 series wireless LAN adapter on an older laptop for my small business. I'm using ACU v5.05. For some reason, the ACU won't associate w/ my wireless network unless I disable WEP encryption. I'm not sure what to do next. Any ide...

shanawanih by Community Member
  • 747 Views
  • 2 replies
  • 0 Helpful votes

HiHas anyone had success deploying a vocera solution over aironet and WLSM?I have been asked to look into the best way of securing the wireless for a vocera solution but don't know where to start.I would imagine that setting up a voice vlan on the ac...

I am presently investigating the capabilities of WLAN's to network vehicles travelling between 50 - 100km per hour. The plan is to use bridges to interconnect vehicles in a point to multi-point configuration. Is there a known limitation on 802.11g th...

RNZNc4i by Community Member
  • 548 Views
  • 1 replies
  • 0 Helpful votes

We are using WindowsXP SP2 zero configuration and ACS4.0 with EAP-PEAP authentication. The wireless client authenticaiton is ok, but our concern is the client's ID/Passwords is saved in Windows and is not popup ID/Passwords request after first auth s...

yong1794 by Level 3
  • 981 Views
  • 3 replies
  • 0 Helpful votes

Is it possible to use eap-fast authentication with CCKM on 7920 phone with WLC.It is working when configuring 802.1x and wep 104 bits on controller but it does not work with wpa1+wpa2.

secoffey by Community Member
  • 3107 Views
  • 12 replies
  • 0 Helpful votes
Top Solution Authors
Review Cisco Networking for a $25 gift card