Wireless

Can someone recommend a good wireless sniffer for capturing problems after authenticating to the AP? Getting a lot of calls with users login scripts not running or servers not being found. Reboot, and it works just fine. Its like hit and miss, very w...

On WiSM-A, I have client associate with AP-A and WiSM-A local WLAN is 192.168.A.0, then as I roam to WiSM-B while the local WLAN is 192.168.B.0, and I can maintain my original IP but WiSM-B has no knowledge about 192.168.A.0, I don't know how WiSM-B ...

Does anyone know the 15.4W output power per user port in the current 802.3af is the min. or max.? I've seen conflicting info on different vendor's spec sheet. If it's the max., then why are some "802.3af" injectors outputting as much as 1A.

How does one setup the Radius server to return the allowed SSID for that user.In this case FreeRadius will be used.Cisco suggested that to avoid VLAN hopping, one should have the 802.1X RADIUS server return a list of permissible SSIDs for each authen...

I was trying to set up Cisco877w and Aironet1121 G as a repeater. All works fine without any security on. However when I put WPA with shared key, Access point cannot associate to router anymore. I used config example from cisco.com and it doesn't wor...

hi:i have a bbsm 5.3 appliance, but unfortunatly i only access web pages, my point is how configure my bbsm as to alow internal vpn clients to connect through bbsm.regards

I have a been contracted to setup a small WLAN inside hotel conference areas for meetings that will last 1 week each, 4 times a year. Every year 2 of the meetings will be in the U.S. and 2 will be in Europe(i.e. Greece, France, Germany etc.)My equipm...

I have a problem with 802.1x. I am using a 3560 and Windows XP SP2. Everything work fine except when I boot up from cold. It appears that by the time windows boot the EAp request has timed out and I am getting put into the guest / auth-fail vlan. If ...

Has anyone experience licensing issues when upgrading WCS 3.0 to 4.x? Unable to import new license files received from TAC into WCS box. Still waiting on TAC for a solution.

Hi guys,Is there a Cisco a/b/g integrated diversity antenna with 4 cables that a Cisco 1242 AP can support all the -a and -b/g client with only one antenna?Thanks,yytellmey

Hello,We have installed 40 AP in our building, thus using Cisco 1010/1020 Ligthweight AP and 4400-50 series Contollers.In some places, the laptop connect sometimes to bad signal AP instead of the one beeing vary close, thus bringing vary bad connecti...

We are upgrading 800 APs to lightweight. I know the upgrade tool can only upgrade 6 APs at a time. Can I run the Upgrade tool on two different computers at the same time so that I can upgrade more than 6?

I have a question, I'm pretty familar with 802.11B Networks, I however am slightly confused when seeking to develop an IP Oriented solution for a Carrier Company we're working with. They seek utilization of Mobile IP within the following context. The...