Wireless

I am not sure if this is the correct place to ask the following questions, but here it goes...As part of a wireless pilot project we have installed 50 access points (Cisco aironet 1231G) in a couple of buildings. The real project once approved could ...

I am setting a wireless interconnection. In the Head Office I have a Cisco 1310 root Bridge and in the remote office I have the Cisco 1310 acting as the bridge. My question is - Could I directly connect the Cisco Access Point to the Cisco Aironet Pow...

Hi,We have to implement wireless lan with WRT5RG devices.We have the reason to use only this model.Our question is how much area one accesspoint can cover. Based on that we will decide how many access points we have to purchase?Regardsskrao

AP boots fine on ac power but drops power entirely upon connecting ethernet cable.

I have an aironet 1100 configured as the root and I want the aironet 350 as the repeater. After all is setup I keep receiving authentication failed messages on the log of the 1100. any thoughts?

I have setup a lwapp system with about 6 AP's. Everything works great but on one of the WLAN's I have Web Authentication setup. For some reason, I cannot get this to work. I have tried every setting possible, played with the virtual interface but I c...

I tested windows XP SP2 client PEAP machine authentication with ACS server. The ACS uses self signed certificate. I have to uncheck "Validate server certificate", otherwise machine authenticaion does not work even I have imported the ACS self signed ...

When do you enable the ethernet multicast mode on controller? In my test lab, I have it disabled and I have not seen any issues so far. Thanks.

At the informational link below - we are informed that when using LAN interfaces for failover link you must go through a switch and not use a cross-over cable between the two pixes in the pair. It does not however explain why this is the case. Does a...

I have 3 BR1310 units, all on 12.3(8)JA2, and set to use WPA-PSK. One unit will be located outside a main building and acts as the Root. The second unit will be located on a small hill and act as the Repeater. The third unit will be located at a remo...

Original bought AIR-ANT4941 and 1200 to replace 1100 for better coverage. It appears the 4941 antenna is eqaul to intergrated antenna of 1100. What antenna is the next step up for indoor use to increase coverage

I have setup PEAP with ACS Server and it works fine on Windows XP. How can I connect Windows 2000-SP4 PC to the access point with PEAP? Wireless service is running and I have enabled 802.1X with PEAP under the Authentication tab of the network card.W...

I've got 3 x 1020 AP's and a 2000 WLAN controller. The 2000 is controlling the AP's power and channel selection, and I can see they're 1, 6 and 11 respectively. All seems fine however for the odd long call(<15mins) the call hangs and the phone re-ass...

I have Symbol handhelds with B radios which up until 12.3(8)JA used to associate and authenticate fine. We isolated the problem in 12.3(8)JA to the AP's having 1 and 2 Mbit rates disabled, once these were enabled all is fine again.Anybody know what c...