Wireless

Im receiving a duplicate ip address fault from WLSE loopback address of 127.0.0.1. Is this possible? The fault description says "Duplicate ip address detected. Please check the Duplicate IP folder in the Device tree." I do not see any Duplicate ip fo...

I am getting some messages from WLSE that I have not been able to find on Cisco's WEB site. Tow examples are: WLSE failed to authenticate with WDS and Inconsistent state found for query "interface.radio.config"

Folks, If i have an a,b,g radio in tha Access Points, will APs detect a,b,g rouge access points and report it to WLSE.Thanks

Hi!Running ACS 3.3(2) mapped with NT domain (which the ACS server belongs to). Is it possible to also authenticate wireless users belonging to other domains or user databases at the same time..?

I've been searching for some config examples, but don't seem to be coming up with much on this. I have 2 AP1232s that I'd like to use temporarily as a building to building wireless bridge to trunk 6 VLANs to my new office (100 yards away). I've got...

I´m having problems with some clients ,of my aironet 1200 i´ve ched the log and i´found a warning with the message "Packet to client XXX.XXX.XXX reached max retries, removing the client".The radio signal is good .I´ve tried to solve it disabling the ...

We're currently evaluating the Airespace thin AP solution. We have three 1000 series APs, two converted 1200 series APs and one 1131 AP, of which we run a subset of four APs placed in a loose square form in a drywall/concrete office environment, all ...

Will a Cisco 1220 access point support dual radios with POE?

I have a customer that is having roaming issues. The logs show the following message:Interface Dot11Radio0, Deauthenticating Station 000f.f84e.ac6c Reason: Previous authentication no longer valid Packet to client 000f.f84e.ac6c reached max retries, ...

Hi all,I was a little too quick on the gun yesterday and updated the wrong firmware file [c1200-rcvk9w8-tar.123-7.jx.tar] instead of the right one [c1200-k9w7-tar.123.7.ja2.tar] using the browser to my AP1200. Now, the ap boots up, but gives me an er...

Is it possible to do site surveys with the Aironet 1200 .I´ve seached the configurations via web browser and could not find any thing related.Or is there a command via telnet to do it ?Thanks

Is this possible?AP1242AG(50mW Bridge Mode with 6dBi Patch Antenna)---(0.5mile)---BR1410(250mW Bridge with 6dBi Patch Antenna). Bandwidth should be over 10Mbps.I think AP1242AG maximum power is low(50mW). SO, AP1242AG's signal is not reach to BR1410 ...

We are experimenting with our first couple of 1310 Bridges. We find the GUI interface to be VERY slow (1+ minute for updates to each screen) even though we are connected from a PC via X-over cable to Ethernet port on the injector. Is this normal? ...

Does anyone know how to reset the 1010 to factory if it does not find the controller?

Hi I am planning to setup fully wireless lan for my company staff. We have 3 floors of office space. Each floor (oval shape) is visible from one end to other and has about 150 users. How should I find out how many AP's and which AP's to used to maint...